Electronics Forum | Fri Jun 19 19:52:34 EDT 2020 | davef
Has the snow melted up there yet? I'm aware of ppl that might give you a lead ... + Advanced ESD Services near Binghamton, NY 607-759-8133 dbellmoreATechoes.net + EOS/ESD Association, Inc. 7900 Turin Rd, Building 3, Rome, New York 13440, USA | 315
Electronics Forum | Thu Jun 25 19:38:48 EDT 2020 | SMTA-Marjory
Thanks, im looking at everything at this point
Electronics Forum | Wed Jun 24 14:10:01 EDT 2020 | stephendo
When I was looking into it previously it looked like you could pay a large fee and have your paperwork audited. I didn't find having auditors coming in and checking that you were actually following your paperwork. Having your ESD S20-20 procedures au
Electronics Forum | Wed Jun 24 13:03:35 EDT 2020 | SMTA-Marjory
Dave, thanks for the info...my issue is the border is closed so i'm trying to find a Canadian source. If you have anything can you send it to jason.tong@apagcosyst.com thanks
Electronics Forum | Thu Jun 18 19:23:28 EDT 2020 | SMTA-Marjory
Hi i'm looking for someone or some organization to perform an audit and certify my facility. We are located in Windsor ON. NOTE i was informed that our QMS auditor, TUV Nord, does not provide this service. Any help someone could provide would be gre
Electronics Forum | Wed Nov 29 21:04:32 EST 2017 | davef
Yes, "corrosion" should be on your buyers spec for ESD mats. ESD mats are another one of those sneaky little gotcha things, where it's easy to think that all blue mats are the same. Kapon tape is another one where you can't purchase strictly based
Electronics Forum | Tue Dec 14 02:19:03 EST 2010 | sachu_70
With lower Humidity levels, we expose to greater risk towards ESD related failures seen on components. Pl. ensure to have your entire work area fully guarded against ESD and maintain proper material handling instructions across the entire flowline un
Electronics Forum | Fri Feb 17 07:32:49 EST 2006 | Chunks
I depends on your components, your ESD program, and the max rating your equipment can deal with.
Electronics Forum | Thu Feb 16 18:14:45 EST 2006 | Geo E
We have just purchased a humidity logger and I need to know what the relitive humidity should be in a SMT production area. The Room is enclosed approx. 60ft by 30ft using ESD Floor tile. 3 machines are in the room as well as some Thru hole machines.
Electronics Forum | Wed Nov 29 20:54:32 EST 2017 | truthseeker
DAVEF: In "Soldermask - sulfur presence" [http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=16291&#Message66659], how did you determined that sulfur was coming out of mats onto boards?
