Electronics Forum | Wed Jul 20 13:46:17 EDT 2011 | mosborne1
Does anyone have a source for high temp PCB racks? Fancort makes them, but they do not make high temp racks like we need. We used to buy Calmark and they do not make them any longer..
Electronics Forum | Wed Aug 03 11:21:34 EDT 2011 | davef
We don't know what you mean by 'high temperature' Board storage racks * FKN Systek http://www.fknsystek.com/PCB%20Racks.htm * US Plastic http://www.usplastic.com/catalog/item.aspx?itemid=24577&catid=745 * All-Spec http://www.all-spec.com/products/
Electronics Forum | Tue Aug 09 12:43:29 EDT 2011 | sys_steven
I used InsulFab to make some for me in the past, ran into the same issue. They did an excellent job
Electronics Forum | Tue Jul 15 15:39:24 EDT 2014 | ahernand75
Hello, I'm looking to buy PCB magazine for my SMT process and would like to have feedback about Nikko products. Any comment about them is welcome and thanks in advance for your support.
Electronics Forum | Wed Aug 13 03:49:14 EDT 2014 | stgpcba
We can't provide you pcb magazine,but only PCBs if you interested. www.China-pcbassembly.com
Electronics Forum | Thu Aug 04 07:50:49 EDT 2011 | mosborne1
Thanks Dave - IF you look ath the Fancort RA-18HT. This is a high temp plastic that will handle 350 F. This is what we need, but in the 8 1/2 by 20 size. No one seems to make them now. We are a bare board manufacturer as well se wee bake boards at hi
Electronics Forum | Tue Aug 12 16:46:00 EDT 2014 | tombstonesmt
Hello, I'm looking to buy PCB magazine for my > SMT process and would like to have feedback about > Nikko products. Any comment about them is welcome > and thanks in advance for your support. All of our SMT racks are Nikko. They work great but I
Electronics Forum | Wed May 04 10:42:55 EDT 2005 | nice90
Handling a PCB 1. Check your ESD slippers and ESD Strap first before entering the SMT production line 2. A PCB manufactred over 90 days must be stored first on the baking Oven before Production 3. Temperature on the Baking oven must be 125plus and m
Electronics Forum | Sun Feb 23 14:51:02 EST 2003 | davef
Without being clear on whether you're talking about: * Standard air knives at the back-end of your in-line cleaner ... OR * Hand held or similar nozzle. Standard air knives: This causes no problem with ESD because the relative humidity is so high t
Electronics Forum | Fri Feb 21 16:08:56 EST 2003 | clarkk
Hello all, We use pressurized air from a blower to blow off excess water from our pcb assemblies after wash. I'm concerned that this could potentially cause esd damage to sensitive assemblies. Is anyone aware of a device that can correctly ionize the
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
