Electronics Forum | Tue Jul 07 05:28:49 EDT 2009 | kpm135
In my experience tape is bad when packaging trays. I've always seen them packaged with the banded straps when coming from manufactures or brokers. For repackaging we either use ESD safe rubber bands or ESD safe velcro straps.
Electronics Forum | Tue Oct 12 13:03:18 EDT 2021 | cunningham
Afternoon all, Do you use any special surface other that ESD matting when changing over matrix trays? We currently use a earthed wire trolley that we keep trays and MSD bags on and when replenishing stock its carried out on the trolley. Does anyon
Electronics Forum | Wed May 04 10:42:55 EDT 2005 | nice90
Handling a PCB 1. Check your ESD slippers and ESD Strap first before entering the SMT production line 2. A PCB manufactred over 90 days must be stored first on the baking Oven before Production 3. Temperature on the Baking oven must be 125plus and m
Electronics Forum | Sun Feb 23 14:51:02 EST 2003 | davef
Without being clear on whether you're talking about: * Standard air knives at the back-end of your in-line cleaner ... OR * Hand held or similar nozzle. Standard air knives: This causes no problem with ESD because the relative humidity is so high t
Electronics Forum | Fri Feb 21 16:08:56 EST 2003 | clarkk
Hello all, We use pressurized air from a blower to blow off excess water from our pcb assemblies after wash. I'm concerned that this could potentially cause esd damage to sensitive assemblies. Is anyone aware of a device that can correctly ionize the
Electronics Forum | Mon May 13 23:44:26 EDT 2019 | dami0629
if use tray cannot solve the problem, you can change from the design 1）Reduce the effect of temperature on PCB 2) PCB USE HIGH TG 3) BOARD THICKNESS TOO THIN 4) MODIFY THE BOARD SIZE 5) Reduce the V-CUT depth.
Electronics Forum | Thu Jun 14 20:33:50 EDT 2018 | davef
Try: AGI: agicorp.com/products/tooling/wash-baskets 256-858-3300 JENSEN Tools: jensentools.com/desco-41403-esd-safe-pcb-wash-tray-liner-18-x-18/p/482-89 800-225-5370 Stone Mountain Tool: stonemountaintool.com/fixtures/products/wash-fixtures/ 800-
Electronics Forum | Fri Jan 07 17:45:15 EST 2005 | russ
My thoughts on metal trays: One problem with a metal tray relating to ESD is its conductivity. Most trays are conductive but have resistance or a disipative nature. If you were to place a "charged" component into a metal tray that had an uncontrol
Electronics Forum | Wed Jun 19 00:07:10 EDT 2002 | kenbliss
arzucom, have you considered using trays to handle your boards in process and your handbuilds. This method is fast becoming the industry standard method for a large variety of reasons, specifically ESD as when the boards are in the tray your people
Electronics Forum | Wed Jun 19 00:07:31 EDT 2002 | kenbliss
arzucom, have you considered using trays to handle your boards in process and your handbuilds. This method is fast becoming the industry standard method for a large variety of reasons, specifically ESD as when the boards are in the tray your people
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
