Electronics Forum | Wed Jun 20 12:55:29 EDT 2018 | reckless
Which compact oven manufacturer makes a better product? Essemtec or DDM? The Essemtec units look the same as Manncorp. I have found 2 RO300FC's and a Novastar 1800. The 1800 looks like it hits a higher temperature but not sure if its needed to go
Electronics Forum | Thu Sep 13 15:09:07 EDT 2018 | reckless
So it took me a few months to figure out the compact reflow oven market. I bought the following ovens: Heller 1500EXL Essemtec RO300FC-C - QTY 2 DDM Novastar Gold Flow - Desktop DDM Novastar 1800HT - Conveyor Zevatech 5 zone oven T962C benchtop ove
Electronics Forum | Fri Feb 26 08:30:10 EST 2010 | davef
Low cost prototyping * TWS Automation Quadra [www.tws-automation.com 39 0585 634758] * Versatronic RV4 [VSMT Solutions Ltd; 6 Dean Way, Aston Clinton, Aylesbury HP22 5GB, Buckinghamshire; 01296 630341 F01296 632144 http://www.vsmt.co.uk; David Clemen
Electronics Forum | Mon Oct 18 08:02:35 EDT 2010 | marusha
Hello, colleagues! Please help make a choice! (MY500 + MYDATA MY100 + Heller Mk1707) or (Dec Horizon03 + Samsung 421 + Essemtec RO400FC-C) or very cheap Korean equipment (Sj InnoTech; HP-520 + Mirrae Mx350P + TSM; A70-i71). The volume of required c
Electronics Forum | Mon Dec 22 18:20:22 EST 2014 | sreejhu
Hello, Also I wanted to tell you. I decided to go with a brand new machine. Please tell me which is the best machine for mid Volume. Samsung, heller, Dima, essemtec, acto USA, C.I.F Which company do you suggest me.. The best. My duties: We have boa
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Sun Dec 25 18:54:04 EST 2005 | mariss
We are experiencing fracture problems with 0805 X7R capacitors. The capacitors seem to fail in tension; during hot-air rework they come apart in two pieces with the fracture near the metallization end. Only X7R SMT components are affected, C0G and Y
Electronics Forum | Fri Nov 06 08:50:07 EST 2009 | jeffreyj
adlsmt - I do apply paste (Kester EP256) by hand to the boards now with 5 mil thick stainless steel stencils. A few of the parts almost always need rework, though, either because I didn't place them accurately or there's too much paste, or it got sme
1 |