Electronics Forum | Fri Aug 19 14:01:02 EDT 2011 | davidalvarez
We just acquired an RO-260E reflow oven for doing prototypes and very small production runs, we are currently having issues with the conveyor motor. Before we got the oven the persons that had it before did some modifications to the conveyor system
Electronics Forum | Sun Jul 21 10:33:53 EDT 2019 | reckless
I use a lead free 3 zone essemtec oven which I love. It's on the smaller side (wish it was even smaller). It works fine in our application. Maximum width is 300mm and only uses 5-6kwh average (25A max). Made in Switzerland. For some reason I don
Electronics Forum | Mon Nov 29 01:58:43 EST 2010 | leo_dektec
Hello Sir, Here is a link you can take look. http://www.deksmt.com The machine I would like to recommend you is BM-W430 and BM-W630. We are a major manufacture of reflow oven and wave solder in China, till now we have distributos in more than 16
Electronics Forum | Sat Jul 23 02:16:52 EDT 2022 | poly
Is there are reason for going for larger (or smaller) boards when designing panels for use with a chain conveyor oven? My panels range from 0.6mm 2 layer (for touch with hatched ground) to 1.6mm 4 layer. I'm planning to go for smaller panels to reduc
Electronics Forum | Wed Jun 20 12:55:29 EDT 2018 | reckless
Which compact oven manufacturer makes a better product? Essemtec or DDM? The Essemtec units look the same as Manncorp. I have found 2 RO300FC's and a Novastar 1800. The 1800 looks like it hits a higher temperature but not sure if its needed to go
Electronics Forum | Wed Jul 16 03:03:36 EDT 2008 | lococost
if it's still under warranty, why dont you let essemtec fix it?
Electronics Forum | Sat Feb 26 13:56:22 EST 2022 | poly
I was looking to swap a Universal GC60 from 240 to 400 V 3 phase. I can get a transformer though and just looked at prices and they are quite cheap. My 2 main options at the moment: Option a: 1 Universal Genesis (2006) some feeders + essemtec ove
Electronics Forum | Fri May 11 11:15:03 EDT 2012 | shawnvike
Good question and always fun to wade through all the issues. We currently run an Essemtec FLX2010 and a Manncorp CR-6000 oven. Our printer is an Essemtec SP002 (I think) guided manual. We have been running the Essemtec equipment for ~6 years and ha
Electronics Forum | Tue Jul 15 13:42:36 EDT 2008 | dwelch123
Ed, sounds like your tech. is full of *hit. He must be fatter and lazier than me!! I'd call Essemtec and make sure that his statement is correct, and if it's true, Gabriella is right. Have a good one bud.
Electronics Forum | Thu Jul 24 00:35:43 EDT 2008 | chip_flip
I would remove enough links to get the tensioning assembly back where you have room for adjustment again. I would have to agree that if the machine is still under warranty you should have Essemtec correct the issue.
