Electronics Forum | Thu Jul 18 12:45:49 EDT 2019 | dekhead
Lots of things it could be (basics first): E-Stop pressed. Connections within E-stop circuit (mostly Y4). Connection of SYSTEM switch back to Y4. E-stop relay. Do double pushbuttons toggle partial SYSTEM?
Electronics Forum | Mon Aug 31 03:24:54 EDT 2020 | jmelson
I don't know this exact machine, but it likely has similar logic to some other Samsung machines. The E-stop buttons have TWO sections. One shuts off the "main start" button, the other informs the computer that the button has been pressed. If you d
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Sat Dec 30 18:49:39 EST 2006 | A.S.
TRY TO REPROGRAM THE AXISES AND CHECK THE WIRES GOING TO THE E-STOP BUTTON THESE PROBLEMS CAN CUASE THESE ERROS TO KEEP COMING UP TRY THIS AND YOU MAY FIX YOUR PROBLEM
Electronics Forum | Wed Oct 16 15:43:37 EDT 2024 | rup
Some of those older machines have a fuse behind the e-stop button.
Electronics Forum | Wed Apr 25 14:10:00 EDT 2018 | irc
hello, I'm learning to use the oven 1809 exl and when I try to put it on the Estop button is on all the time and allows use of the oven I read in the manual but I can not find an answer to deactivate it, could you tell me how I can disable this butto
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
Electronics Forum | Thu Oct 20 19:23:18 EDT 2011 | eadthem
As far as the buttons go, White = pause for inspection when depressed, lit when active Green = pass after inspection when lit you need to press the button, when flashing its waiting for the upline machine, Yellow/orange = when flashing indicates
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Mon Aug 31 15:39:18 EDT 2020 | jmelson
Yes, the rightmost VME board is the IO_DPRAM, and it also handles the front panel buttons and E-stop inputs to the computer(s). So, reseat the connectors on the front of that board. Also, there may be an interface board on the bottom left (called C
winsouce.jpg)
