Electronics Forum | Fri Sep 29 04:43:12 EDT 2017 | spoiltforchoice
Interesting, I work much the same way as Ivan up to the sticky tape part, plodding through the BOM against the pick and place file and downloading the relevant datasheets to verify packages, this can be tedious but usually gets much quicker the more
Electronics Forum | Thu Jul 09 23:55:07 EDT 2015 | navworx
As mentioned, I'm looking for opinions, pro & con, comparing these two machines. Cost, performance, whether you think it's an apples-apples comparison, etc. Would like to hear from those who: 1. Have used Europlacer machines and now use MyData mac
Electronics Forum | Tue Dec 22 17:32:17 EST 2020 | atpico
We are looking to buy a 2nd hand Europlacer p-n-p. We would be very grateful to have a real production competent opinion about EP feeders/trolleys Questions: 1. generally how good/bad are older (Gen1, Gen2) Europlacer feeders and trolleys systems
Electronics Forum | Tue Jan 05 07:31:34 EST 2021 | atpico
Great! Thank you! What about Gen1 vs Gen2(NT) EP feeders (not feeder elements)
Electronics Forum | Tue Jan 30 14:27:17 EST 2024 | redspare1
I'm in the USA. Yes, we are going to self support or use other old machines to get this going. Which speedprint / Europlacer would you recommend?
Electronics Forum | Mon Mar 09 12:52:38 EDT 2015 | brianbrl
Hi, I had Assembleon machines for many years, and worked through a total of nine of them. Three years ago we began to look at the short-comings we had, based on the machines capabilities. We started to look for a new SMT platform that could improve
Electronics Forum | Sun Mar 18 20:15:06 EDT 2018 | stephenj37824
Thanks so much for the reply. I had looked at Juki but must have missed that model. I see what you are saying about the dispensing. I was looking at the Mycronic solder jet system the My700 I believe. I have watched a few videos detailing the pros an
Electronics Forum | Tue Jan 30 14:18:22 EST 2024 | spoiltforchoice
It might be worth mentioning that Speedprint (now Europlacer) printers also have a calibrate using your own board capability. They arguably also target higher mix environments given that is the market the pick and place machine targets. DEK uses a v
Electronics Forum | Wed Dec 13 22:22:04 EST 2017 | deanm
As mentioned above, Mycronic and Europlacer seem to be designed toward high mix so would consider them but would also like to consider a more traditional machine too. Right now I have around 220 feeder slots across two machines inline. Mycronic and E
Electronics Forum | Tue Aug 07 20:40:19 EDT 2001 | davef
As Stefan says, it�s tough to comment on Linux / SCO features of Euroland machines, because you don�t see Linux. You can say Linux / SCO is faster, less crashy, and cheaper than Windows machines. [Same reasons most internet servers run Linux. Hmmm
