Electronics Forum | Thu Mar 25 16:10:31 EST 1999 | Chrys Shea
| I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | I believe that we need to visit SMTnet Banne
Electronics Forum | Mon Mar 29 07:08:59 EST 1999 | Wayne Bracy
| | I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. | | | | I believe that we need to visit SMTnet
Electronics Forum | Sat Apr 29 12:18:07 EDT 2023 | poly
I have finally got a calibration kit for my single beam multi function Genesis. Calibration finishes successfully, I then attempt to pick a part with the 7 spindle head and it gives me a collision error. The error occurs even when I don't have a no
Electronics Forum | Mon Nov 20 13:53:13 EST 2023 | carl_p
I would ensure a nozzle is fitted to spindle 1, UIC genesis, Fuzion etc can be a bit funny with this. If that checks out ok, I would be ensuring nothing is obstructing the Z travel. Next would be to ensure the Z motor is at home & again this is wor
Electronics Forum | Thu Nov 16 22:55:14 EST 2023 | dwl
Do you have to have at least 1 nozzle on the head? I think the lightning heads you had to have at least 1 nozzle on the head or it would give an error.
Electronics Forum | Mon Nov 20 14:10:02 EST 2023 | ttheis
Check pin mirrors and the z touchdown sensors are responding correctly.
Electronics Forum | Wed May 01 13:24:21 EDT 2024 | poly
Turns out I cleaned the pin mirrors and then did the rest of the PM steps and fixed it... regular PM is important!
Electronics Forum | Wed Mar 18 11:53:29 EST 1998 | Mike Masters
Is there anyone out there required by their customer to clean the finget tab contacts even after using noclean paste? We have been asked to clean even though we don't have any flux residue on the contacts. Any ideas? Mike
Electronics Forum | Fri Dec 20 12:12:12 EST 2002 | russ
Thanks Dave, I was looking in the Murata data base and couldn't even find the part (Even though they are the ones making it)let alone the pad dims. This part looks like it could be fun anyway. Russ
Electronics Forum | Tue Feb 08 06:43:56 EST 2005 | dhanashekar
we have even tried with 6mil stencil even than we are getting the solder ball thanks for your suggestion
winsouce.jpg)
