Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Fri Feb 21 17:12:43 EST 2020 | SMTA-Alex
Have you performed the maintenance? It might need grease, or there might be excess old grease, that's putting more friction on the Hydra Z. Check if there might be interference from the vacuum tubes or wires.
Electronics Forum | Mon Jul 29 18:51:47 EDT 2002 | davef
Consider: * Printing: errors [ie, insufficient, excess, skipping, etc.] paste doesn�t roll in front of squeegee, paste adheres to squeegee at the end of stroke, paste does not release. * Component placement: orientation, wrong component, missing comp
Electronics Forum | Wed Mar 23 05:17:23 EDT 2011 | arwankhoiruddin
Hi All. I want to know what is the IPC/JEDEC standard for solder paste printing defects. From the brochures of SPI Machines, the recognized defects are excessive, insufficient, misalignment, no solder, bridging, and solder shape error. What document
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Thu Oct 26 13:56:08 EDT 2000 | ptvianc
Hello: Pre-baking laminates should only be performed:(1) to meet contractual agreements or (2) in response to an actual defect that can be traced to PWB water absortion. Besides the fact that a pre-bake is an enormous process "bottleneck," it also
Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Mon Jul 16 16:28:18 EDT 2012 | mikesewell
I'm somewhat frazzled by this one, not being too familiar with the MYs. Head is clean, tried different tools, same tool# from another MY, and have run the Centering Base Level Calibration to no avail. The component heights are correct and the par
Electronics Forum | Thu Aug 06 18:08:41 EDT 1998 | Earl Moon
No sour grapes, This has gone on too long. I expect no free advertising, nor do I seek it. It is clearly understood Bob is an industry leading consultant. What is not understood, at least by me, how he is allowed to "advertise" so freely on this foru
.gif)
winsouce.jpg)
