Electronics Forum | Sun Apr 02 08:45:30 EDT 2017 | davef
Other clean room exhibitions * Cleanroom Technology https://www.cleanroomtechnology.com/events/events_page * Clean Zone https://cleanzone.messefrankfurt.com/frankfurt/en/exhibitors/willkommen.html * Cleanroom Exhibition Istanbul https://www.tradefa
Electronics Forum | Wed Jul 06 22:20:46 EDT 2005 | vera1001
hi everyone: The Nepcon exhibition of SMT field will be held at shenzhen city in China. www.nepconchina.com
Electronics Forum | Sun Apr 16 11:16:27 EDT 2017 | davef
Other clean room exhibitions * Cleanroom Technology https://www.cleanroomtechnology.com/events/events_page * Clean Zone https://cleanzone.messefrankfurt.com/frankfurt/en/exhibitors/willkommen.html * Cleanroom Exhibition Istanbul https://www.trade
Electronics Forum | Thu Sep 15 03:49:56 EDT 2011 | lisalau
Dear all, We are going to attend the NEPCON exhibition in Korea next year,can anybody assisst me on the time and place ? Thanks&best regards! Lisa
Electronics Forum | Thu Sep 15 21:05:29 EDT 2011 | lisalau
thank you very much Dave,it's been very helpful..
Electronics Forum | Fri Mar 31 23:19:37 EDT 2017 | clcte01
International Confederation of Contamination Control Societies (ICCCS) is keep attention to the world's cleanroom economic and technology industry development in the recent year. What i know one cleanroom exhibition in Guangzhou, China. They are dev
Electronics Forum | Tue Jul 10 19:16:08 EDT 2007 | 5why
We have filed returned (approx. 5%) of the boards that exhibit inner layer short @ a particular connector locations. X-section revealed there exhibit Cu residue, but aside from that, we also suspect there could be organic contaminant, what test shou
Electronics Forum | Sat Mar 18 13:44:31 EST 2000 | Thomas Ravener
I totally agree. I like the text of Greed Exhibitions, very fitting. I too was an exhibitor. We were in the other... hall. The first day was lacking in the excitement and hustle and bustle of the main floor. APEX did a good job in correcting the lack
Electronics Forum | Wed Dec 13 13:42:57 EST 2000 | Mike Ihm
The dielectic absorption characteristic of printed circuit board materials is usually not listed on the manufacturers spec. sheets. Can anyone point me in a direction to help determine which laminate materials might exhibit better dielectric absorpt
Electronics Forum | Mon Mar 26 11:20:39 EST 2001 | dblsixes
The pads are 0.070 x 0.012 ... as spec'ed, and as measured. The pad extends approximately 0.017 behind where the Class 3 fillet is required to be. (It used to be 0.037 on an older design that exhibited similar, but not as bad of heel fillets.)
