Electronics Forum | Wed Jul 15 22:05:11 EDT 1998 | Stoney Tsai
I have been building one sophisticated SMT soldering expert system (KBS), through my 8-YEARs SMT experience. As I know, in the marketplace only published some SMT raw material selection Expert System. The system needs more technical information about
Electronics Forum | Tue Feb 10 14:45:06 EST 2004 | patthemack
I have an old De Haart printer that has a problem. It will not reset either the z axis or the squeegee. The z axis just gyrates, and I think it's trying to get to the zero position, which is all the way down, but it's already down. Is there a De Haar
Electronics Forum | Thu Feb 12 12:44:50 EST 2004 | Jon Dupree
I worked for deHaart back in the good old days. Which type of printer is it, perhaps I can help.
Electronics Forum | Fri Feb 13 11:04:29 EST 2004 | patthemack
You are a gentleman, and I appreciate you very much. Thank you for the contact, I am sure they can help. Thank you for your time. Blessings to you and your family. Patrick
Electronics Forum | Fri Feb 13 04:09:52 EST 2004 | patthemack
New update: By playing around with some settings in the software, we've been able to get the z-axis to work. This makes me think that if we reload the software, the problem may be fixed. Got any ideas as to where I can get a copy of the MPC-29 softwa
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Wed Jul 21 07:56:17 EDT 2004 | John
Try to check for solder mask on the pads!
Electronics Forum | Sat Jul 25 04:57:17 EDT 1998 | Stoney Tsai
| I have been building one sophisticated SMT soldering expert system (KBS), through my 8-YEARs SMT experience. As I know, in the marketplace only published some SMT raw material selection Expert System. | The system needs more technical information a
Electronics Forum | Mon Jul 19 14:58:50 EDT 2004 | mattkehoe
We have a need for expert opinions on a solderability issue. Our company prints and then reflows solder paste with no components in place. It is then washed and flattened with a special flattening machine. Usually, the paste fuses and spreads out
winsouce.jpg)
