Electronics Forum | Fri Oct 20 14:13:32 EDT 2000 | DENNIS XIONG
Dear all, We have a PCB design mistake that causes exposed copper layers on the edges of breakaway locations. Although we fixed the design, but we already made a lot of boards plus many made before we found the problem. I wonder if any one have some
Electronics Forum | Sat Oct 21 03:55:14 EDT 2000 | DL
Dennis, I've seen this before, and in our case we didn't need to seal the edges because there was no concern of shorting or anything in the end product, this is a choice you will have to make, Does your end product have any protrusions or mounting h
Electronics Forum | Mon Sep 09 21:54:01 EDT 2013 | mandysmile
Hi, rod, The exposed copper area you could do with ENIG. It is with good solderability.
Electronics Forum | Mon Jun 27 09:38:30 EDT 2005 | Bob R.
What problems are the quality people seeing? I hope they aren't expecting a toe fillet. QFNs are typically cut from an array after plating. This leaves exposed copper on the sides of the part. We'll often see smearing from the sawing process that
Electronics Forum | Tue Oct 09 14:30:32 EDT 2012 | bandjwet
Put on your Chemical Thinking Caps..... We are ablating the mask of a PCB which was over a copper layer. This exposes copper. Outside of an electrical test (no can do) how could we use a fast non-destructive test in order to determine that copper (
Electronics Forum | Wed Jul 31 09:20:47 EDT 2002 | larryk
Dave, I'm assuming your unsoldered fids are exposed copper. Do you have any issues with machine vision due to the various color changes the copper goes through as it oxidies? Larry
Electronics Forum | Thu Jan 10 11:22:48 EST 2013 | pbarton
Looks to me like under etching of the underlying copper and the gold is just plated to all of the exposed copper surface. Is this characteristic the same on all solderable pads? You will not be able to remove this gold.
Electronics Forum | Thu Apr 02 11:27:49 EST 1998 | Mike c
I am looking for a product to repair PCB mask (seal exposed copper) and fill Gouges in pcbs, any suggestions?
Electronics Forum | Fri Apr 03 08:26:58 EST 1998 | Scott Cook
| I am looking for a product to repair PCB mask (seal exposed copper) and fill Gouges in pcbs, any suggestions? Why not use an electonic grade 5 minute epoxy? As long as it's inert, I'd do it. Scott
Electronics Forum | Sat Apr 04 15:28:36 EST 1998 | Use one of our UV cure conformal coatings
| | | I am looking for a product to repair PCB mask (seal exposed copper) and fill Gouges in pcbs, any suggestions? | Why not use an electonic grade 5 minute epoxy? | As long as it's inert, I'd do it. | Scott
winsouce.jpg)
