Electronics Forum | Fri Oct 20 14:13:32 EDT 2000 | DENNIS XIONG
Dear all, We have a PCB design mistake that causes exposed copper layers on the edges of breakaway locations. Although we fixed the design, but we already made a lot of boards plus many made before we found the problem. I wonder if any one have some
Electronics Forum | Sat Oct 21 03:55:14 EDT 2000 | DL
Dennis, I've seen this before, and in our case we didn't need to seal the edges because there was no concern of shorting or anything in the end product, this is a choice you will have to make, Does your end product have any protrusions or mounting h
Electronics Forum | Tue Jan 12 11:14:37 EST 2016 | mfgengr2016
After the CCA is been de-paneled I find exposed board fibers. Should the board edge be sealed with an epoxy to keep moisture from getting into the CCA?
Electronics Forum | Thu Jan 14 09:25:34 EST 2016 | davef
IPC-A-610F 10.2.6 Laminate Conditions - Depanelization talks to the acceptability of the depanelization criteria for assembled boards. There is no requirement for moisture sealing with epoxy or other material. Basically, the standard requires that th
Electronics Forum | Tue Apr 01 19:45:07 EDT 2008 | boardhouse
Dave, Sorry for the slow response, have been out of town, The spacing I was referring to was from board edge to copper features. This spacing is required to keep the router and score blades from exposing or hitting the Copper. Regarding the slot I
Electronics Forum | Wed Jun 30 10:37:11 EDT 1999 | Boca
We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design). Inste
Electronics Forum | Sun Sep 09 21:59:36 EDT 2018 | sanneyyu
we are a PCB house, you can add some patterns at breaktabs or board edge, this can help you easily verify copper weight for every circuit layer.
Electronics Forum | Fri Oct 26 05:03:17 EDT 2018 | farouk225
Hi everybody, I have a question about the minimum distance to leave beteween a non non-plated mounting hole with copper pads and the edge of the PCB. Is there any formula or rule to apply ? For example for a hole of diamater equals to 5.6mm which
Electronics Forum | Fri Oct 26 12:29:22 EDT 2018 | davef
I'm not aware of a standard requirement. One screw hole diameter seems to used commonly.
Electronics Forum | Fri Oct 26 13:16:41 EDT 2018 | slthomas
Is there any chance that something like a riv-nut might be used for mounting purposes or is it just a screw hole?
winsouce.jpg)
