Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Fri Feb 14 16:55:07 EST 2020 | bilalfarooqi
Thanks so much Bruce and thanks Rob.
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Mon Feb 10 17:32:59 EST 2020 | SMTA-Alex
Check that the new vacuum tubing isn't restricting the theta rotation. It can "wrap" around the Midas head, if not secured properly.
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Mon Feb 10 22:29:07 EST 2020 | bilalfarooqi
Thanks all. I didn't check any further as I dont want to mess the midas head any further especially because I'm not sure how to take it out to work on it.
Electronics Forum | Fri Feb 14 12:37:08 EST 2020 | bilalfarooqi
Hey Rob, I don't know where the MOT cards are located on MY12 or how to change them. Do you have any documentation or instructions on how to change the MOT cards?
Electronics Forum | Fri Feb 14 14:35:44 EST 2020 | emeto
From what I remember, shut off machine, unplug cable/hose, unscrew 4 screws and the head is out.
Electronics Forum | Tue Nov 15 23:03:07 EST 2011 | supse
Hi I have a problem with one of our MY12 machines, the machine stops very often (approx. 10-20 times a day) writing the following error message : f-mot-msetdyn hydra theta/205(f-hrdw-3). We then have to reinitialize the machine to continue productio
