Electronics Forum | Mon Aug 05 09:39:07 EDT 2019 | filipblad
Hi, I'm getting the F-MOT-MOVE X/156 error on our MY12 pick'n place. The manual tells me its an hardware issue. I found another thread on here where someone had a similar issue and they found out it was a power subbly issue. If I open the service pro
Electronics Forum | Tue May 07 12:30:30 EDT 2013 | shankar2013
We are having a problem with our Mydata TP9-2U where the machine shuts down during a job with this message seen on the service monitor -- F-MOT1-26/156:MOVFI: MOTOR TIMEOUT Has anybody seen this problem?
Electronics Forum | Thu Aug 14 12:57:45 EDT 2014 | rgeary
Does anyone know what the following error indicates on a MyData My12 running 2.9.2. "F-MOT-MSETDYN C/156"?
Electronics Forum | Thu Dec 22 15:11:40 EST 2022 | jbrochecouste
hello, I am looking for information on the following error message: F-MOT-MSETDYN HYDRA Z/156 / TIMEOUT... on a MY12, tell me your experience until the problem is solved
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Tue Nov 13 11:14:15 EST 2012 | jaimebc
For the past few weeks we have experienced an intermitent midas theta error.During normal production the machine times out while just after picking up a component waiting for the theta to center it.Sometimes it fails to leave a tool. Reinitianing the
Electronics Forum | Wed Aug 07 13:32:21 EDT 2019 | rgduval
To isolate the MOT failure, try swapping the MOT card with another MOT card. If the failure moves, then the problem is in the card. If the failure does not move, the MOT card is not your problem. If the MOT card is not the issue, then your problem
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Sat Feb 22 09:41:44 EST 2020 | tomdegas
I am getting a F-MOT-MSEDYN HYDRA Z/156 error when I try to initialize Hardware on my My9. Interestingly though when I go into the "Service" program, I can initialize the Hydra Z with no problem. But when I try in TPSys, it doesn't pass and I get t
1 |