Electronics Forum | Thu Dec 22 15:11:40 EST 2022 | jbrochecouste
hello, I am looking for information on the following error message: F-MOT-MSETDYN HYDRA Z/156 / TIMEOUT... on a MY12, tell me your experience until the problem is solved
Electronics Forum | Thu Oct 11 00:11:49 EDT 2018 | mk15
I am looking for some help for where to look to fix this MY15E problem. We started the machine after the weekend and this error code comes. F-MOT-MSETDYN z/3: Upper end point outside limit. Any suggestions? Thanks
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Fri Feb 14 16:01:28 EST 2020 | bk
On the my12 the panel on the front of the machine comes off two screws each corner to loosen the panel. There is a pull out tray that gives you easier access to the computer, ps3, etc. It will be the box in the center on top it should label where eac
| 1 |
winsouce.jpg)