Electronics Forum | Thu Nov 06 11:12:57 EST 2008 | janz
Hello, One of our pick and place machine uses rietschel vaccum pump. It is making lot of noise. I am in searching alternative solution which could be venturi pumps. Does anyone has experince in changing vaccum pump to venturi system.? What should
Electronics Forum | Mon Nov 10 13:27:07 EST 2008 | evtimov
Hi janz, you should be aware of everything. You are going to change subsystem on your machine. How much vacuum you need on the machine? Can you control the vacuum level with your system? Can you control the the system at all? Is it really much more
Electronics Forum | Fri Mar 27 14:37:49 EDT 2009 | hcglitte
Has anyone any experience with pick and place machines from http://www.mechatronic-systems.com?
Electronics Forum | Wed Aug 20 12:49:12 EDT 2008 | charliedci
We have been running a 2060 for 2 years, along with other older juki/zevatech placement systems. We have also had positve results. Fell free to contact me via e-mail for more specific info. charliem@dciincorporated.com
Electronics Forum | Wed Jan 23 20:02:46 EST 2013 | darby
MACHINE CONFIG> MOUNT R ATTR. You have the choice of REL or ABS. Until you get these sorted and understand the differences you may struggle a bit with rotations. Should be in the manual. I always ran REL, which means the mount angle is relative to th
Electronics Forum | Sat Jun 23 21:04:44 EDT 2001 | Stefan
If you want to tinker a bit with old machines, you could buy an inexpensive ( under $ 10,000 ) used Pick&Place machine and reverse the polarity on the tape feeding motor. If you don't heat seal the cover tape, but use pressure sensitive cover tape,
Electronics Forum | Thu Oct 24 06:01:16 EDT 2002 | Kent
I'm currently dealing with an design of an end effector that need to pick n place a BGA dead bug package. The design is using peumatic system to do the task. Any advise or suggestion on this kind of design?
Electronics Forum | Tue Aug 01 08:57:34 EDT 2000 | CAL
We here at ACI run the CP20 or Manncorp version 2000.We are a Research and engineering Company with availablity for demonstrations. We actually love our system (Esp. the cost). Even though our machine is a low end machine we are placing advanced pack
Electronics Forum | Tue Apr 30 10:01:41 EDT 2013 | dontfeedphils
Here are the P/N that I have in our system, I'm not positive that these are the full P/N or not: Center Belt: E4016725000 Input/Output: E4017725000 Hopefully that helps.
Electronics Forum | Wed Oct 30 09:43:01 EST 2002 | gregp
Larger tighter spaced balls will present a problem in sealing the vacuum cup. There will be more leakage in this case. It really depends upon the application. The BGA you mention should not be a major concern. The bigger problems are with bigger
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
