Electronics Forum | Mon Sep 30 16:16:17 EDT 2019 | stephendo
We use "Uline N95 Deluxe Industrial Respirator" face masks. We are looking for something better. Our conformal coating machine has an active exhaust pulling fumes out and the door is closed when the machine is running. We have a fume hood with an act
Electronics Forum | Tue Oct 01 08:35:03 EDT 2019 | robl
For brush and dip coating we are using professional fume cabinets - https://monmouthscientific.co.uk/products/fume-cupboards/ 1.8m sized.
Electronics Forum | Wed Oct 09 16:19:54 EDT 2019 | cbart
We have draft/vent booths for our folks, we had a local company here make them for us with Black lights built in. they work nicely there is a constant draw. We also had the same company build drying cabinets, they have constant draw/ventilation on th
Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Sun Aug 15 05:45:15 EDT 1999 | Brian
Boca, Dave Sorry, but I cannot let this go. I'll go along with you that, at the time that the Montreal Protocol was initially signed (September 1987), there was no scientific proof that CFCs etc. were causing ozone depletion. There was, however, ve
Electronics Forum | Thu Sep 13 13:04:52 EDT 2018 | jrs192
Hello! Recently started buying PCBs with peelable mask to remove the need for Kapton tape. Had no issues with our first batch, but our supplier has over-cured the second batch - it comes off in tiny bits, and is stuck in the holes. After timing the
Electronics Forum | Wed Oct 29 23:07:42 EDT 2014 | rajz
Help Needed. I face a solder bridging issue on solder mask define pad at edge only for nexlev connector . The pad design such as smd at four corner only. The bridging happen on signal to ground pin only. Current stencil we use 22 round with 6 mils s
Electronics Forum | Fri Jun 24 08:47:14 EDT 2005 | grantp
Hi, There are many aspects to consider. 1. Firstly the room needs to be designed so it's sealed, so linoleum floors than curve where the wall meets the floor, so dirt does not get trapped in the corners, and mops get all dirt and pick it up. Floor
Electronics Forum | Fri Apr 30 13:26:10 EDT 2021 | amaliahx
The pandemic has altered people's habits, causing a surge in demand for home electronic devices. This has swept the global chip supply and disrupted automobile manufacturing. The pandemic has led to the global shortage of semiconductors or chips, and
Electronics Forum | Wed May 17 11:19:44 EDT 2000 | John Thorup
Hi Dave It sounds like you do pretty much what we do. A couple of points: If your machine allows, open, fill and seal the dross container inside the machine. Otherwise, the auxillary exhaust as you describe is a must. Be gentle in your movements. Don
winsouce.jpg)
.gif)
