Electronics Forum | Wed Nov 09 17:22:06 EST 2022 | emeto
1. For laser machines, there should be setting for Z - at what level you should cut measure the part in Z axis. 2. Check all calibrations are in place and passing 3. Check resistor package setup in the software - all dimensions
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Mon Oct 14 11:56:02 EDT 2024 | poly
I just got a used SE500 Ultra and the machine appears to move in the X and Y, conveyor belts and width. It however fails to home. I assume the end sensor has physically moved or it's an issue with the Z axis. The logging says it's axis 0, however th
Electronics Forum | Tue Oct 15 11:15:16 EDT 2024 | poly
It's Z! The Z hall effect sensor connector was broken but it was easy to solder on a new one. I however can't work out how to change conveyor direction, as the directions for updating it in the manual don't appear to work.
Electronics Forum | Fri Oct 25 15:31:27 EDT 2024 | stevea
For assistance to all your CyberOptics support needs, Contact ASC International. http://www.ascinternational.com or 763-479-6210. Thank you. Steve Arneson
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Tue May 03 22:55:53 EDT 2016 | ttheis
Also it might be a failed axis controller card in the VME; check for any red fail lights.
Electronics Forum | Fri Apr 02 14:21:58 EDT 2021 | sacd
deleted
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
