Electronics Forum | Wed Jun 14 11:37:44 EDT 2006 | shawnvike
find the problem? Were the parts failing > electrically? Or did someone start prying them > and decide they were too weak? Originally found the problem going through some older assemblies that had failed testing. Poked at leads and found them no
Electronics Forum | Fri Dec 17 12:09:09 EST 1999 | Boca
Outstanding advice gentlemen! To borrow Dave F's line "I'd like to take a bit of a different angle." Ie. a few wave solder specific issues If this assembly is going over wave solder then avoid vias under passive components, it invites solder bal
Electronics Forum | Wed Nov 09 05:44:06 EST 2005 | grantp
Hi, It sounds like your vision is not setup right for this component, and it's rejecting some of them because they would be failing the test. This brings up a point we discovered. Don't use auto teach for the component if your using HYDRA or vision
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
