Electronics Forum | Tue Jul 19 14:29:12 EDT 2005 | ppwlee
What are possible failure analysis (destructive or non-destructive and what are the pro/cons) I could conduct on the component level (of an IC) to determine failure mode/root cause? We are measuring internal shorts between leads on a SOIC after sold
Electronics Forum | Tue Jul 19 21:24:04 EDT 2005 | davef
This is a bit dated, but it'll give you a starting point. test lab failure analysis IC; Accurel Materials Analysis Group (FIB, FESEM,TEM) 785 Lucerne Dr Sunnyvale, CA 94086; 408-737-3892 Fax 3916 Suzanne Francisco X146 suzannef@accurel.com test la
Electronics Forum | Thu Aug 11 08:23:29 EDT 2005 | jbragg
Hi Peter, I'm not sure where you're located, but I work for Celestica in our Component Failure Analysis and Reliability Testing Lab in Toronto Ontario Canada. We are an idenpendent lab with full FA component, assembly and PWB capabilities and would
Electronics Forum | Tue Nov 30 11:05:37 EST 1999 | Bob Smith
Hi, Can anyone give me the name & address etc. of a lab that will section PCBs and analyze defects? Thanks. Bob
Electronics Forum | Tue Jul 19 17:48:16 EDT 2005 | saragorcos
One step is to examine the cleanliness on and around the failing component. There could be an ionic contaminant causing the shorts. Regards, Sara Gorcos www.residues.com
Electronics Forum | Tue Aug 23 13:25:10 EDT 2005 | MMurison
MUAnalysis is an independent lab for Component Failure Analysis and Reliability Testing in Ottawa, Ontario Canada. We also would be pleased to discuss your analysis needs. We also perform all non-destructive testing, e.g. visual, x-ray, C-SAM, el
Electronics Forum | Tue Feb 08 04:27:55 EST 2011 | thomas111
hi, I am a Hardware designer . One of my products is undergoing a Reliability test in which a resistor shows a high value on board from its specified value .However it retains the original value when its cooled under room temperature. The resistor
Electronics Forum | Tue Nov 30 11:43:02 EST 1999 | Wolfgang Busko
Where should this lab be, means where�s your place, you wouldn�t like to send your boards elsewhere on earth? Wolfgang
Electronics Forum | Tue Nov 30 16:14:27 EST 1999 | Glenn Robertson
Bob - Try John Maxwell at (719) 687-6911. I have seen him do some presentations at the trade shows. Glenn Robertson
Electronics Forum | Tue Nov 30 16:53:57 EST 1999 | Dave F
Bob: consider two thing: 1 Most board fabs have PCB sectioning capabilities 2 Consultants Council Matrix (http://www.ipc.org/html/fsresources.htm) lists consultants that may be able to help you. Ta Dave F
winsouce.jpg)