Electronics Forum | Thu Oct 28 13:36:14 EDT 1999 | Bart Smith
I am a design engineer and have a circuit board design with a 292 pin BGA on it. The board manufacturer is experiencing a failure rate of about 2.8% on the BGA device due to soldering problems. This is my first experience with BGA. How does the 2.
Electronics Forum | Mon Sep 16 09:47:33 EDT 2013 | dilogic
I would appreciate if you can share your experience with pick failure rates, preferably for 0402 parts. Also, what percentage do you consider acceptable?
Electronics Forum | Wed Sep 18 15:41:59 EDT 2013 | cbeneat
For 0402's, if the operator is paying attention, our equipment Panasonic CM 402/602/NPM's run at about .001%. Again this is dependent on an operator that pays attention to the fail rate. We usually don't have too many problems with 0402's, LED's ar
Electronics Forum | Mon Sep 16 13:57:31 EDT 2013 | emeto
By tape manufacturer you can have up to two empty slots in the tape. That means you should have two retries after the first pick up.
Electronics Forum | Tue Sep 17 17:55:36 EDT 2013 | dilogic
Yes, I know all that, but I am interested in some real figures from the field. That is, what percentage of mispicks do you experience on average (for large runs, of course)?
Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Electronics Forum | Fri Oct 29 05:23:00 EDT 1999 | Wolfgang Busko
Hi Bart, that�s much to high. If that would happen to me my boss would tear my head off. For improving the yields you must find the cause for the soldering problems. What are the symptoms? What could be the cause for the symptoms? Could be design pr
Electronics Forum | Thu May 08 10:16:17 EDT 2003 | davef
Observations are: * Center most lead of the fuse on the top right of the assembly looks like it has excellent solder flow, but this is PTH. From the amount of solder, it must have been wave or hand soldered. * Center most lead of the fuse on the bot
Electronics Forum | Thu May 01 13:58:14 EDT 2003 | bremerg
Gentlemen, Does anyone have any failure information on IRC, CHP2-100-R500F (5 OHM, 2W, 1%) resistors. We have experienced two failures on the same circuit board where the metalization on the component separated from the component causing an open ci
Electronics Forum | Wed Feb 17 09:23:00 EST 2016 | ronhammer
Does anyone know what the normal fallout rate is for a 12 layer PCB from the board house during testing? We received the inspection data from a recent set of boards. Looking over the report there failure rate looks high to us, but with out knowing wh
