Electronics Forum | Thu Jul 31 14:58:06 EDT 2014 | rgduval
If it has been determined that it is definitely the relays (and not some other circuit device), you'll want to get the vendor/manufacturer involved for some failure analysis. They'll cut open the components, and try to figure out what's going on in
Electronics Forum | Mon Feb 25 16:08:14 EST 2008 | fsw
All, I am of the opinion that electromigration is very different from dendrite formation. Is it different or one & the same. Anyone have any feedback on this?
Electronics Forum | Thu Jul 31 15:14:59 EDT 2014 | kenkay
Turns out the seal was being broken from poor handling allowing moisture in. Thanks for all the info pointing me in the right direction!!
Electronics Forum | Mon Feb 25 22:04:30 EST 2008 | davef
Here�s background on: * Electromigration: http://en.wikipedia.org/wiki/Electromigration * Dendrite: http://en.wikipedia.org/wiki/Dendrite_(crystal) For us, electromigration is the electrochemical process that creates dendrites. As a bonus, here's
Electronics Forum | Tue Jul 29 14:25:20 EDT 2014 | kenkay
We have been struggling for a while with some through hole sealed mechanical relays that fail at test after they have been sitting a while. They will initially pass test, but seem to fail if they sit for a few days. We made sure our wave process was
Electronics Forum | Wed Jul 30 07:41:08 EDT 2014 | williamaxler
I have seen similar issues in the past. 1. We had an issue when the relays were installed a leg was bent over. This cracked the epoxy base and allowed water and flux to get in. 2. We have had to bake relays after washing. We would cut open the
Electronics Forum | Tue Sep 01 15:18:04 EDT 2009 | babe7362000
Is there anyone out there that can help me with a Y1 axis failure on a Meridian 1030? It seems to be an intermittant problem but is now getting worse. Please let me know if you can help
Electronics Forum | Wed Apr 27 12:12:22 EDT 2016 | 123test
Hi, were you able to find out what caused the failures? We arr seeing the same issue in one of our project as well. The resistoris from IRC. Thanks!
Electronics Forum | Tue Dec 14 11:05:43 EST 2010 | baildl632
We just received a Paragon 150 oven for production. We hadn't used it a week and we're getting "Top Blower Fail " alarm. I have checked all the top blower fans and they all are running. Can someone help as to why we're in alarm yet all the blowers ar
Electronics Forum | Tue Dec 14 15:34:51 EST 2010 | baildl632
Thanks for the insight and advice.
winsouce.jpg)
