Electronics Forum | Fri Sep 20 14:23:50 EDT 2002 | larryk
PizzaFred, Scott mentioned lots of good ideas. Take one of your boards to each vendor and see what it takes to program the board how long it takes for it to become online. I've found some that are easy to program, but require 40 or more assemblies to
Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Tue Jun 29 11:46:36 EDT 2010 | davef
Prins: Everyone has equations. Here's one some people use: False call rate = [Number of defective boards, but good at inspection]/[Total number of boards produced] Why don't you ask the people [that calculated the numbers that confuse you] how the
Electronics Forum | Sat Jun 26 02:32:32 EDT 2010 | prinsisgarcee
how do i calculate false call rate? i got this equation = [over reject / (total solder joints + components) ] * 1000000 and i got a table which shows data like number of solder joints, components on panel, and number of false call, and the false
Electronics Forum | Fri Jul 09 19:20:49 EDT 2010 | rway
This table, is it in a database? And is it indicating the number of component, solder insp. etc based on one board or one panel? It needs to be based on the total number of inspection on your panelized pcb. The equation works, you may just be look
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Thu Nov 01 09:23:27 EDT 2007 | pjc
If you are in the Americas, I'd contact tech support and they should square you away on that high false call rate problem. They have great WebEx training and troubleshooting. www.mirtecusa.com
Electronics Forum | Wed Jun 19 14:40:58 EDT 2024 | davidk
Hello Carl, Thank you for your comment Obviously, we are evolving and debugging our test to get the best results ("no escapes no false calls") :) and using a combination of 3D and 2D tests. With the previous AOI, we had a much higher false call rate,
Electronics Forum | Fri Jun 07 14:05:39 EDT 2024 | davidk
I wanted to open a discussion and ask about opinion: What is a normal result of the inspection of an AOI? How many falls calls per component /opportunity is bad/normal/good? How many defects per component/opportunity is bad/normal/good? What is goo
Electronics Forum | Thu Jun 13 08:10:51 EDT 2024 | carl_p
You would need to be more specific on the AOI in question here. 2D, 3D features will also have a big impact. Are you constantly evolving or updating the models to improve the situation or going from just the base program as if low volume it can be a
