Electronics Forum | Tue Jul 30 01:56:49 EDT 2024 | hostlace
Check the machine's display or control panel for any particular fault codes or warnings. These can help you understand the exact nature of the soft parameter mistake. Consult the machine's user handbook or technical literature. The handbook frequentl
Electronics Forum | Fri Apr 07 05:10:29 EDT 2023 | abhishek10
Reverse Polarity Defect in diode.what could be the reason and how to avoid it. We have the issue facing in NPM and CM machines of panasonic.Any investigation would help.
Electronics Forum | Tue Jul 25 07:55:06 EDT 2023 | shrikant_borkar
check pill of tape check for feeder calibration .(get it thru the Panasonic service center ) monitor feeder wise and batch-wise performance it will let you know the issue on the machine
Electronics Forum | Tue Oct 05 18:07:53 EDT 1999 | Bill Haynes
I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Our pa
Electronics Forum | Wed May 08 04:46:25 EDT 2013 | mbb
Hello, I want to ask what are causes that could engender rejected components in Panasonic pick and place machine?
Electronics Forum | Wed Jun 24 17:52:20 EDT 1998 | Wayne
| A wishful thinking of the component mfgs! | The machine suppliers prepared themself with | different designed bulk feeders ( I like the | Sanyo design best ) and expecting the customers | of testing their products. | With some of the bulk feeders I
Electronics Forum | Wed Mar 20 15:01:37 EDT 2024 | linux
Reboot usually does the trick, Reason for these fault, (1) Nozzle holder, the grippers are holding the nozzle too tight, stretch the spring slightly, (2) shaft is sticking, removed the head lubricate the shaft.(3) Nest not opening and closed within t
Electronics Forum | Mon Sep 24 17:38:18 EDT 2001 | mparker
First question - do you have a rework station? If so, are you experiencing the same type of failures there? I have successfully used no-clean on uBGA's in the past. 6 mil solder bumps, 10 mil spacing. 88 sites. Are you reusing previously soldered uB
Electronics Forum | Tue Oct 05 18:37:19 EDT 1999 | Morris
| I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Our
Electronics Forum | Wed Oct 06 08:55:23 EDT 1999 | Brian Conner
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
