Electronics Forum | Mon Jan 10 03:12:27 EST 2005 | technitelec
are you looking for a used one or a new one, may i know what is the exact Fuji number is it fcp4-2 or fcp4-3 machine??? thank you serge
Electronics Forum | Thu Aug 16 14:02:08 EDT 2012 | benreben
Hi all, i search the proper method for adjusting gain/offset on fuji FCP4 can you help me? thx
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Sat Aug 22 00:11:49 EDT 1998 | Arul vanan
We are using PCBs of CEM3 Material with bare copper fiducials. The whole board is of bare copper with a lacquer coating (Coats brother S2974). The fiducials are of 1 mm diameter bare copper. we use Panasert MV2F as well as FUji CP4-3. In both the mac
Electronics Forum | Fri Feb 12 19:40:42 EST 2010 | rodrigo
I posted the message below on Friday and today Monday I started looking at the problem again. We have a computer with a setup that works. It is the original PC we bought with the F4G but it is set up for a machine we do now have ,IP3. I was looking a
Electronics Forum | Tue Aug 25 12:50:24 EDT 1998 | Lance Smalley
To see if the MV will recognize the marks, in the binary mode, when setting threshold (binary level), raise up the level until the edge of the mark starts to degrade. Write down the number. Lower the level until the fiducial starts to "bloom". Wri
Electronics Forum | Thu Feb 11 18:51:49 EST 2010 | rodrigo
Hi All, I'm setting up the F4G software for our line (currently using MCS30). I made an adapter to connect the CP4 line (that was connected to the MCS30) to the PC. Then I tried to transmit a program but I keep getting this error: 41A27F9D: Error o
| 1 |
winsouce.jpg)