Electronics Forum | Tue Nov 25 10:40:50 EST 2003 | Fuji_Dude
Try putting on new springs on the feeders. This a common and frustrating problem with CP6/7 feeders.
Electronics Forum | Fri Jul 21 15:29:20 EDT 2006 | choppy
I've seen something like that on our CP5. The problem was the nut retaining the leadscrew to the bearing (motor side) that became too tight due to an error from the operator.
Electronics Forum | Wed Jun 27 09:17:43 EDT 2007 | gregf912
I have set the PQ with the CP6 station jigs. It is dialed in to 0.02mm of zero. I also checked station 5.
Electronics Forum | Tue Jul 02 10:37:36 EDT 2019 | dman97
I also forgot to add that if the proper data was not generated by flexa for the CP6, then flexa will not communicate with the machine. You need to flush the proper and resend using flexa for the communications to work correcty. Good luck!
Electronics Forum | Fri Jul 19 11:02:15 EDT 2019 | dman97
You never answered my question on the proper data. Do you have a hard copy of the proper data? Is the diskette (if you have it) in Fuji Flexa format? In order for flexa to communicate with the CP6, you must have the correct proper data.
Electronics Forum | Fri Jul 19 11:16:21 EDT 2019 | dman97
And yes if the proper data is not correct it will give you a error message because Flexa cannot communicate with the CP6.
Electronics Forum | Wed Jun 23 10:05:17 EDT 2004 | exmaintenanceleader
Hi Grant, I'm ex Fuji service engineer I install also at Sagem Czecz Republik (Kladnow near Prague) in 2000 they use at new lines MPM- 2XCP643E and 1xUniversal GSM (French owen (I do not remember the exacly tipe) at second hand line they use 2x and
Electronics Forum | Thu Aug 22 02:18:09 EDT 2002 | mjabure
Specify the nozzle size as 1.4 in both the nozzle allocation table and the PD, the nozzles will still pass center test as the size variation is still within tolerence.
Electronics Forum | Thu Aug 22 23:18:03 EDT 2002 | mjabure
you're welcome. if you have any other questions you can e-mail me, my address here is mjabure@smtnet.com. Used to be a machine instructor for fuji.
Electronics Forum | Mon Jul 28 21:21:46 EDT 2003 | danielchan
hello Ryan, you can post me pictures & details of your 0402 part placement. i will try to help. regards danielchan apexservice@apexsmt.com