Electronics Forum | Wed Jun 27 09:15:21 EDT 2007 | gregf912
The program that I use is the Fuji calibration program and it works fine on all other equipment that I use it on. The PDs are dialed in at 10% tolerance and the nozzles are new. I see it more on 105 and 1608 parts but it happens on 2012 and 3216 part
Electronics Forum | Fri Feb 22 08:23:51 EST 2008 | aj
All, I understand that there is a requirement to upgrade the narrow view camera on the Fuji CP642 to place 0201 components - is this necessary ? Also, 1 - What tape package to they come in ? Can you use 0402 feeders? aj...
Electronics Forum | Tue Jul 13 21:05:04 EDT 2010 | dman97
Thanks for the replies. Indeed the amplifier needed to be tuned. I have recalibrated it and all is working as it should. Thanks for the advice.
Electronics Forum | Tue Jul 23 12:28:20 EDT 2013 | empac
Hello, We are looking for a Fuji IP3 and cp642 technician . Please contact us at 503-396-4200 if you are interested . Regards, David
Electronics Forum | Mon Jun 29 08:50:55 EDT 2015 | tdemon69
looking for some one that works on these machine for a living, that my company can higher from time to time to do some work on them.
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Mon Jun 17 21:32:17 EDT 2019 | reckless
We are looking for a Fuji Technician in Chicago to setup and train on a Fuji CP-642. Send PM if interested.
Electronics Forum | Fri May 08 17:55:37 EDT 2020 | cyber_wolf
The squish is determined by the spring in the nozzle. If Z0 or table level is out, you would see it on more than one component..most likely Make sure board thickness and component height are correct. Also make sure you have board support installe
Electronics Forum | Wed Aug 25 21:41:12 EDT 2021 | same problem
I'm having same problem with one of my CP-642s. We checked cards and now the monitors are not turning on.
Electronics Forum | Thu Aug 22 02:18:09 EDT 2002 | mjabure
Specify the nozzle size as 1.4 in both the nozzle allocation table and the PD, the nozzles will still pass center test as the size variation is still within tolerence.