Electronics Forum | Wed Aug 25 21:41:12 EDT 2021 | same problem
I'm having same problem with one of my CP-642s. We checked cards and now the monitors are not turning on.
Electronics Forum | Sat Dec 16 09:43:39 EST 2023 | madisreivik
I know, but actually we have very "deep knowledge" of that machine, probably much deeper than we wanted :) So, if any information about nozzles please share !
Electronics Forum | Mon Dec 18 14:06:10 EST 2023 | cyber_wolf
I would check with these guys. One or both most likely have these jigs. http://www.ibesmt.com/ https://www.smtresearch.com/
Electronics Forum | Thu Dec 28 08:10:13 EST 2023 | vickey
Always follow the manufacturer's guidelines and recommendations when troubleshooting or performing maintenance on the equipment. If you're unsure about any step, it's advisable to seek assistance from Fuji's technical support or a qualified service t
Electronics Forum | Mon Nov 24 19:21:04 EST 2003 | alwil
Hi, I have seen this problem. Make sure that the peeler tape goes round all three pulleys as in the diagram on the feeder. Make sure the feeder clutch is oil free and not slipping. If everything is set correctly then it may be a component vendor i
Electronics Forum | Wed Jun 27 08:33:27 EDT 2007 | pekantol
Have you measured the preQ rotation station(st3).Is it workin correctly?
Electronics Forum | Thu Jan 24 10:27:09 EST 2008 | vikkaraja
Sorry I did not response to you sooner. I will do my best to get that info. to you as soon as possible.
Electronics Forum | Thu Jun 25 08:34:31 EDT 2009 | cyber_wolf
Banging and knocking is not good. The noise that we hear on ours is more of a whining. .1mm runout and rough edges = time to replace in my opinion.
Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz
My first guess, loose wire or bad cable. Email me and I will send you a checklist.
