Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Sun Nov 24 12:44:10 EST 2019 | bane016
I have problem with feeder cart.I have no voltage on any of the 17 feeder connectors, and when i insert the cart in the machine i get the message that the cart is not connected. I have a voltage to one separate connector normally.
Electronics Forum | Wed Dec 20 22:54:28 EST 2006 | fastek
I think that in this day and age.....if you are not testing the feeder via some sort of indexing proceedure while the feeder is off of the machine.....you are simply not going to be certain the feeder is working properly. The Alternative SMT jig do
Electronics Forum | Tue Feb 06 18:46:13 EST 2007 | darby
Imagine you put two 8mm feeders on the rear feeder plate, they are about the same distance apart as the length of your tray. On top of these feeders are two slotted arms that allow you to move the arms towards the moveable rail. You place your tray o
Electronics Forum | Thu Jan 31 17:25:14 EST 2008 | jmelson
The tubes don't fit the feeders? I have a Contact Systems vibratory feeder base on my CSM84. It comes with 8 lanes of SOIC only. Well, I use a wider variety of the small chips, from SSOP to wide SO's. The feeder base has some threaded holes in th
Electronics Forum | Tue Mar 30 10:57:54 EST 1999 | Steve Gregory
Hello, I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. My problem is how to assign the correct feeder width to various devices in a simulation. Is
Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Fri Oct 01 14:06:08 EDT 2004 | russ
after we teach their positions We tape the sticks down. It is also helpful to make sure that you tighten the "discs" that are located on the tension rods. There are available if you desire guides and stops from Samsung that attach directly to the fe
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Sat Oct 20 00:34:57 EDT 2001 | kenbliss
Hi mike The solution is simple but two fold, first your process needs to be changed a bit, you need additional feeders to pre-stage the new P/N run and prestage the extra feeders for reload as certain higher volume components exhaust. The idea is t
