Electronics Forum | Sat Oct 08 04:24:37 EDT 2016 | aaronpainter
We are having an issue with the solder bars hanging the solder feeder dripping down the back side of the pot, and leaking in to the area where the terminal block for the elements on the pot are. We have tried aluminum tape to close off the gap betwee
Electronics Forum | Tue Mar 22 03:39:33 EDT 2016 | annabella
Can You Get Your Questions Answered on the Spot? Dear Enrichium: Do you have this same problem? When they decided to switch to our company, my clients often told me that whenever they had questions regarding their SMT Feeder orders from their former
Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Thu Sep 22 13:05:29 EDT 2016 | chabscan
Hi I would like to know the process in wich the Quad 4C knows it has the correct component after taking it from the feeder. Recently I've been put in charge of a Quad 4C machine that is used to assemble two different boards. Each one has already a
Electronics Forum | Thu May 12 00:18:55 EDT 2016 | darby
Sorry for delay - been flat out. Sr - I understand what you are saying. My concern is that combined with the head offsets and variations in pick points (i.e. having to teach feeder positions for very slight amounts like 0.05mm)then you cycle times wi
Electronics Forum | Mon May 16 16:44:34 EDT 2016 | joe98375
Hello, I am interested to see what kind of preferences pop up in regards to SMT PnP machines that fit our production model. Currently we have an old Contact 3Z machine that is giving us nothing but problems in regards to support, spare parts, feeder
Electronics Forum | Fri Jun 03 12:44:46 EDT 2016 | cyber_wolf
"and most importantly inexpensive" Define inexpensive... I always get fired up about "expensive" Expensive compared to what is my question ? A car? a house? If you want what you are speaking of, you will be spending some coin. If you want, semi r
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
winsouce.jpg)