Electronics Forum | Tue May 21 15:30:21 EDT 2013 | williamaxler
There is two different ways to make this work. To get the Add Project button enabled find your EasyOLP installation folder and modify OLPoptions.ini change MultiProject to 1. Now you will be able to add multiple jobs together and optimize. You c
Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Thu Feb 27 15:21:37 EST 2014 | idscraigsmith
My company uses a Juki KE-2020L and a Juki KE-1070L pick and place. I am trying to locate feeder trolley's with feeder banks that would be compatible with these machines but am having a hard time finding anything. Anyone have suggestions of where t
Electronics Forum | Mon Oct 08 14:48:54 EDT 2018 | tey422
Need help on how to fix or temporary fix to bypass the "Rear feeder bank in lower position" error for the Juki 2080 machine. Even replace with different feeder bank won't fix. Any suggestions?
Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Thu Jun 18 15:04:32 EDT 2015 | empac
We have Juki 2000 series feeder carts. Let us know if you have any interest. Thanks.
Electronics Forum | Fri Feb 28 03:13:16 EST 2014 | smtspareparts
Craig,we just make juki cf/af/ff feeders,but hasn't encountered such problems,perhaps I did not very understand the intention,normally install reels on proper feeders,and install feeders on proper position of feeder trolley,but you want realize more
Electronics Forum | Tue Mar 04 10:36:10 EST 2014 | charliedci
We have a KE2060, 2080 and an older 750. All of these use same feeder trolleys. I presume the 2020 and 1070 also offer same trolley compatibility. If machines are not set up for trolleys, you will need conversion kits to utilize trolleys, which sho
Electronics Forum | Fri Jun 06 02:35:06 EDT 2014 | maciejbilu
Got it. That make sense. Pick position is quite far from these "normal" one. I ignore the message (and press start button again) every time and the whole mounting process starts normally. JUKI mount every component assigned except one from 44mm feede
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
winsouce.jpg)
.gif)