Electronics Forum | Fri Sep 02 11:26:50 EDT 2011 | steffenr
Overkill for sure! Program to BOM: Shouldn't have to verify the program to the BOM once it's been verified unless there is a change. Feeder to BOM" There should be some type of instruction that specifies that part goes on what feeder and where the
Electronics Forum | Tue Aug 23 12:58:16 EDT 2011 | emeto
Hello everyone, we are contract manufacturer and I am wondering if we can save some time from inspection and verification. We will usually inspect the bare boards, then, verify program to BOM, then feeders to BOM and Feeders to program,then paste ins
Electronics Forum | Tue Sep 06 09:20:04 EDT 2011 | emeto
Thank you dor your inputs! I was also thinking that once we verified the program to BOM and feeders, we shouldnt check to the BOM after palcement, but we should just AOI. Can you see any other weak points?
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Thu May 09 12:29:59 EDT 2002 | dougt
So after barcoding takes place, is this info sent to the feeder or the outside world (is the feeder just a number that the pick and place machine looks for or does the feeder tell the machine what it has)? I guess if every machine and remote feeder f
Electronics Forum | Mon May 13 10:16:53 EDT 2002 | pjc
After bar-coding or manual data entry the data is in the Mydata database. The data is not stored in the feeder but in the database. The database links the component data to a serialized feeder and to a PCB s/n or production batch code. The machine so
Electronics Forum | Mon Dec 04 23:57:44 EST 2006 | Tom Scherer
HEllo, I was wondering if you have any information where I can obtain a used fuji feeder jig? I am looking for the simole one with no screens or anything, just the simple one.PLease advise?? Tom Scherer Control Products Inc. 763-213-3302
Electronics Forum | Wed Jan 06 14:34:20 EST 2010 | ppwlee
Hi, Has anyone have experience with manual soldering iron using automated wire feed? I am looking at poke yoke manual soldering 5 pins LCD and wondering if there are ways to control the volume of the solder applied to the board to minimize missing s
Electronics Forum | Thu Jan 14 15:36:23 EST 2010 | tds
JBC Tools has a wire solder feed solder iron. You can control how much is dispensed to the tip. I have sold several of these to customers soldering wires in to terminals. The hand piece is bigger than the typical solder iron but it beats the alter
Electronics Forum | Tue Sep 27 17:23:57 EDT 2011 | ck_the_flip
We use Assembleon FT-series feeders.
