Electronics Forum | Thu Sep 24 06:48:55 EDT 2015 | tercel
Thank you for the fast response and help! Machine runs fine again!
Electronics Forum | Wed Sep 23 08:29:19 EDT 2015 | tercel
Hi, I read about the problem "243 x drift adjustment no good" on a Philips CSM 60 (my type) and other machines of this type. I have the same problem but no manual for the machine to solve it. Do you still have the manual where the "Drift ajustment" i
Electronics Forum | Thu Sep 24 06:50:47 EDT 2015 | tercel
btw: Pots are VR16(x) and VR 17(y) on the left board and VR17(r) on the right board.
Electronics Forum | Thu Sep 24 07:07:44 EDT 2015 | ermani9
Great News!! Happy to hear!! Yes. Location of these ports vary for different Models of control cards of machine.
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Tue Nov 23 08:46:19 EST 2004 | mmjm_1099
Has anyone else used the Multi-Job Balancer? I am considering this but of course cost is slowing down the decision making. On average we do a 30-60 feeder setup and switch out to about 4 jobs a day. So any input would be highly appreciated.
Electronics Forum | Thu Jan 31 17:25:14 EST 2008 | jmelson
The tubes don't fit the feeders? I have a Contact Systems vibratory feeder base on my CSM84. It comes with 8 lanes of SOIC only. Well, I use a wider variety of the small chips, from SSOP to wide SO's. The feeder base has some threaded holes in th
Electronics Forum | Thu Nov 28 11:23:35 EST 2019 | csm
Dear All I would like to know your opinion and comments about Universal GC-60D performance to mount high volume for component 0402's, do you recommend this machine? we are working to get one GC-60D or the Panasonic CM402 machine. I just have exper
Electronics Forum | Fri Nov 29 14:45:36 EST 2019 | csm
Dear Alexey I appreciatte your comments and suggestions, we have some old machines and we will replace some of them but unfortunatelly budget is limited. We say videos where we can see the GC-60D working and it looks good. Regards
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl