Electronics Forum | Mon Dec 03 14:53:54 EST 2007 | jmelson
Well, it mostly does. The explanation and how-to-fix fields of the error chart do contain some howlingly bad translations. But, the how to fix field said the management info needed to be cleared. Once I understood they meant the MIS statistical dat
Electronics Forum | Sun Dec 02 00:17:35 EST 2007 | jmelson
I finally figured it out - in my manual it shows as a "63:Overflow" and says it has run out of memory for management information. I finally realized they were talking about the MIS statistical data of feeders, heads and mounting programs. I cleared
Electronics Forum | Mon Jul 26 03:32:31 EDT 1999 | Jason
| | | Hello, | | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | | I'm in charge of the installation of this kind of system
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Thu Jul 15 11:28:24 EDT 1999 | Russ Supersano
I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and Ser
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Thu Jul 15 21:10:53 EDT 1999 | Scott McKee
| I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and S
Electronics Forum | Fri Jul 16 05:48:06 EDT 1999 | Wayne Sanita
Give Mydata a call as Scott said, they will take step by step over the phone. Wayne | | I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed an
Electronics Forum | Mon Sep 29 16:20:08 EDT 2014 | rgduval
Our success rates with MyData vibe feeder were always tentative. Sometimes you'd get it to go great, sometimes, not so much. MyData allows you to control frequency and amplitude on the vibration. Trying various combinations of the two was key to g
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
