Electronics Forum | Wed Sep 12 10:49:46 EDT 2012 | cyber_wolf
Sounds like the feed cylinder sensor. Its a air cylinder hooked to the tape feeder advancing mechanism in the rear of the machine. Go into the I/O and make sure the sensor is changing state when you flag it.
Electronics Forum | Mon Sep 10 12:18:05 EDT 2012 | benreben
Hi, what's the feeding sensor error? the sensor for cartrige or the sensor on cylinder up of feeder? manual is step mode? if you have the number of error at screen,i have the fuji error code help. in step mode the machine is very slowly,maybe the a
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
Electronics Forum | Thu Jan 31 17:25:14 EST 2008 | jmelson
The tubes don't fit the feeders? I have a Contact Systems vibratory feeder base on my CSM84. It comes with 8 lanes of SOIC only. Well, I use a wider variety of the small chips, from SSOP to wide SO's. The feeder base has some threaded holes in th
Electronics Forum | Fri Feb 01 12:52:31 EST 2013 | ericrr
Interesting enough, it did turn out to be alignment, maybe the machine is getting bend & twisted just like people do when they get old....... or maybe I should say as the beam gets less intense with old age the sensor needs to be readjusted to pick u
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Tue Nov 04 12:56:51 EST 2008 | jdumont
I was thinking that there must be an excel macro floating around here that can just compare the two lists of data (feeder setups) and spit out what the differences are. Maybe ill create one...
Electronics Forum | Fri May 12 09:56:29 EDT 2006 | JB
have you ever thought about teaching the feeder as a repeat pickup? 1st before the sensor and 2nd at the sensor.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723