Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Wed Apr 17 05:21:50 EDT 2013 | navbill
Hi, We have QSV-1 machines with stock Quad IQ feeders (8 pins). Some of these feeders will produce a "feeder does not exist" error on both the pick and place machine as well as the OLS station. Is this a problem that can be fixed by us or do the f
Electronics Forum | Fri Apr 19 05:26:22 EDT 2013 | bobpan
There should be a sticker on the feeder that says 10-??????. This is the feeder part number. I think the IQ feeder manual tells you at what point the feeders will communicate with the IQ software.
Electronics Forum | Thu Apr 18 14:09:57 EDT 2013 | bobpan
Just because a feeder has 8 pins on the front does NOT mean it is IQ. The IQ feeders started at a certain level of feeder part number.....which i do not remember being that many people dont use the IQ system. Good Luck
Electronics Forum | Thu Apr 18 17:42:26 EDT 2013 | navworx
Just because a feeder has 8 pins on the front > does NOT mean it is IQ. The IQ feeders started at > a certain level of feeder part number.....which i > do not remember being that many people dont use > the IQ system. > > Good Luck It has PLD v
Electronics Forum | Sun Feb 03 07:41:29 EST 2019 | dfl
Anyway, after both procedures, the feeder still advancing more than 4mm (like 12mm or so)
Electronics Forum | Sun Feb 03 07:39:27 EST 2019 | dfl
POCKET POSITION PROGRAMMING This procedure ensures the components are properly centered at the tape feeder pickup point (over spring stabilizer). NOTE: The feeder can be reset at any time by removing it from the feeder base and reinserting it. This
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Tue Feb 06 10:43:18 EST 2007 | James
Especially on capacitors, the tape is so thick that the motor starts to slow down and does not advance the parts fast enough or not at all. This happens on regular 8mm.
Electronics Forum | Wed Apr 18 15:10:35 EDT 2012 | smtivan
Dear Colleagues! Our organization has a lot of not-intellectual feeders for Essemtec Pick&Place CSM7000, but we would like to use this feeders in Essemtec CSM7100. Does it possible? What will we need to do for normal work of CSM7100 with old feeders