Electronics Forum | Mon Mar 12 18:14:44 EST 2001 | reconsales
We stock over 3000 used Panasert feeders and have many parts in stock. We can also repair / calibrate your feeders with our PFA factory alignment fixture. Please provide us with an accurate description of the parts you need. Give an accurate descri
Electronics Forum | Thu Jul 28 10:42:25 EDT 2016 | mnorthey
We use the Juki electric feeders, I have not seen the mechanical ones. The reel holder is the only problem we have had with these feeders(cheaply built). That said our operators are trained to change a feeder in less than one minute, (originally it w
Electronics Forum | Wed Jan 18 15:21:58 EST 2006 | adlsmt
FYI, if you are using 13" reels, for 8mm parts, you need a different feeder with a larger reel holder. If you get the larger reel holder and if you are using quick change carts, you need the cart for that type of feeder as they also make one that doe
Electronics Forum | Tue May 08 08:26:15 EDT 2001 | caldon
Yes Siemens has a fixed tray feeder for matrix trays. If I remember correctly the tray will occupy 1/2 of the table.The feeder is a two part system 1) is the base 2) the the flat tray (just like what is used in the waffle pack changer). the flat tray
Electronics Forum | Thu Dec 04 15:27:26 EST 2008 | jax
Check the spring tension on the reel holder. When the reels start running out of parts the spring can provide enough tension to keep the reel from spinning. I have seen this on some of the dual-lane feeders. Tape the spring back to verify. If this is
Electronics Forum | Mon Dec 08 07:52:22 EST 2008 | vleasher
Check the spring tension on the reel holder. When > the reels start running out of parts the spring > can provide enough tension to keep the reel from > spinning. I have seen this on some of the > dual-lane feeders. Tape the spring back to > ver
Electronics Forum | Thu Mar 31 04:39:56 EST 2005 | zsolt
Hello All, we have 2 CP842 on site and they are running simply perfect. We used our existing CP feeders (with the small reel holder). CP843 can compensate pick-up both in X and Y direction. also measuring the height of the part with a laser sensor.
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Fri Apr 06 02:17:15 EDT 2018 | rob
@ Sr.Tech, Most of our Chinese spares are Juki & Yamaha original & still bagged, just much cheaper. They wouldn't sell machines in China if all the spares and consumables were at European mark ups. Nozzle wise the Juki 750 & 760 copies are not 100%
