Electronics Forum | Sat Oct 08 16:17:43 EDT 2005 | tmv
in hsp 4796 particularly come this problem. the feeder shutter lever is strikly beloved and stopper was opened.how to clear this problem.
Electronics Forum | Mon Oct 10 14:43:19 EDT 2005 | cyber_wolf
"the feeder shutter lever is strikly beloved" I don't understand......
Electronics Forum | Wed Feb 23 17:23:36 EST 2005 | Brent Robinson
Another this to check is the feeder itself and packaging. The feeders have a little shutter covering the part when the feeder advances. We have noticed a static charge build up in that, or the parts, causing the part to pull out of the pocket when
Electronics Forum | Fri Sep 20 09:07:21 EDT 2002 | cyber_wolf
You are right. It is getting indexed twice. Once by the feed lever and once by the feed cylinder.
Electronics Forum | Thu May 08 09:00:03 EDT 2003 | stefwitt
I like to find out more about your feeder manufacturer. Known problems: If the cover tape peel back is located in the pick up window, the tape may lift the component out of the pocket and when the component falls back it could be inverted. The co
Electronics Forum | Thu Nov 29 15:52:53 EST 2007 | jmelson
Some other machines are a lot simpler. Here's how the Philips (mady by Yamaha) CSM84 works. Smaller tape (8 and 12 mm) feeders are all mechanical. A plunger on the head pushes a lever on the feeder at the same time the head comes down. First, the
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Wed Feb 27 04:23:13 EST 2008 | fujillews
Hi It is best to fit the VGA camera for 0201 parts make sure your software is high enough..above v1.33 although you can place without but no so good. 0.4mm tapered nozzles are best. 0201 feeder the locator base in increased by aprox 0.3mm and the ind
Electronics Forum | Fri Feb 25 23:26:27 EST 2005 | siverts
Good point [engguy], and another thing; if you are using 1.3mm nozzle on a feeder that has a shutter opening of 1.0mm = problem. You could even damage the nozzle. So the main questions remain....
Electronics Forum | Thu Jul 08 02:32:47 EDT 2010 | tivux
I soldered a wire in the tape press lever of th feeder, so as to create a small gap where the cover tape passes and the component doesn't: in this way the component is pushed down in the pocket as soon as it tries to follow the cover tape. regards,
.gif)
.png)