Electronics Forum | Sat Feb 05 05:10:53 EST 2000 | Dean
It would be helpful to have some additional info on your line and process. Lets make some assumptions... Consider: re-tooling costs for your fab supplier. Can your supplier hold the additional tollerences for a larger panel. Can your supplier fab
Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Electronics Forum | Wed Oct 10 11:20:31 EDT 2007 | jdengler
Do all 0201's reject at the same rate? If even 1 P/N has a lower reject rate this can point towards a feeder problem. I have had a similar problem on a CP-IV-2 with 0402's that was caused by feeders. If all reject at the same rate it can be the PD o
Electronics Forum | Thu Oct 11 06:36:57 EDT 2007 | cyber_wolf
Feeder is brand new. (Checked cal. even though it was new) Lighting is good. Machine is in perfect cal. Nozzles are brand spankin new from Fuji. I was able to lower the reject rate considerably by playing with the offset and gain. I am placing caps
Electronics Forum | Fri Aug 26 03:49:17 EDT 2005 | aj
Mark, Is there really that much to a CP43 feeder that its worth the hassle of making a "calibration jig". Train your Operators properly and that should do the trick I have a CP43 and Reject rate runs at
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
Electronics Forum | Tue Apr 10 11:36:46 EDT 2007 | Pro 2000 inc.
Hi there, I recently bought a used Samsung CP30V placement machine witch is about the same machine as a Quad QSA30V. We need to replace some defective nozzles, add some feeders and find spare parts. Where should I look for to get all of these. We tr
Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Thu Sep 01 08:15:51 EDT 2005 | jdengler
The 1CA0A009 would lead me to believe that the PD's may not be as accurate as possible. If the PD is bad then every location that uses that PD will have about the same error rate. The 12040403 would lead me to believe the feeders are haveing trouble.
Electronics Forum | Sun Nov 08 10:41:11 EST 2009 | rao
Excellent Web OEE calculator... For Ideal Cycle time we use to take Programming Cycle Time but in this calculator it seems you have taken Equipment Rated CPH. For a Given Board & the placement locations the rated CPH is not at all attainable because
