Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Wed Apr 08 04:29:14 EDT 2009 | kircchoffs
Hi Rodrigo, is your problem occurs only at 2nd device table? how about if you transfer the feeders to the 1st device table? if it happens at both device pls your part data if there's a value at pick-up. you can also check the proper data of the de
Electronics Forum | Tue Apr 07 12:47:09 EDT 2009 | rodrigo
Hi All, Our CP6-4000 machine has this weird issue that happens once in a blue moon and only on table two. Lets say it is going to pick up a part from feeder 10. Well, it doesn't stop at the right position. It is slightly off so the thing pushing dow
Electronics Forum | Wed Apr 08 10:19:19 EDT 2009 | cyber_wolf
Go into the program screen at the machine and look at the device offsets. See if there is an offset for the feeder. I have also seen a bug on CP4 machines that is like what you described. Switching to the camera view corrected it. (wide/narrow)
Electronics Forum | Mon Apr 01 17:50:31 EST 2002 | stefwitt
the good and bad days are normal results of statistics. You enter some variables like number of feeders, length of part numbers, day of the week, sexual satisfaction of the operator a.s.f. , you get some statistical distribution. It tells us that on
Electronics Forum | Fri Apr 07 03:10:20 EDT 2006 | Roland G
Check firmware version and Fuji upgrade reports because it could be a sofware bug. I remember also 1 random failure on IP1 which was hard to identify: a cable in raceway connected to placement table was getting contact failure when table moves.
Electronics Forum | Thu Jan 13 15:08:22 EST 2022 | emeto
Hello Jeff, error is telling you exactly what it is - communication problem. CAN interface is interrupted somewhere. Motors are constantly sharing position and commands with computer over CAN interface. To get this message means somewhere this circui
Electronics Forum | Mon May 14 16:39:38 EDT 2001 | T.F.
Siemens makes feeder hold down brackets for the F5 that does prevent the operator from leaving the feeder in a position that can cause a crash. The brackets attach to the feeder table so you need one bracket per table. The part part number for the b