Electronics Forum | Thu Feb 27 15:21:37 EST 2014 | idscraigsmith
My company uses a Juki KE-2020L and a Juki KE-1070L pick and place. I am trying to locate feeder trolley's with feeder banks that would be compatible with these machines but am having a hard time finding anything. Anyone have suggestions of where t
Electronics Forum | Tue Mar 04 10:36:10 EST 2014 | charliedci
We have a KE2060, 2080 and an older 750. All of these use same feeder trolleys. I presume the 2020 and 1070 also offer same trolley compatibility. If machines are not set up for trolleys, you will need conversion kits to utilize trolleys, which sho
Electronics Forum | Fri Feb 28 03:13:16 EST 2014 | smtspareparts
Craig,we just make juki cf/af/ff feeders,but hasn't encountered such problems,perhaps I did not very understand the intention,normally install reels on proper feeders,and install feeders on proper position of feeder trolley,but you want realize more
Electronics Forum | Thu Jun 18 15:04:32 EDT 2015 | empac
We have Juki 2000 series feeder carts. Let us know if you have any interest. Thanks.
Electronics Forum | Sat Jan 28 16:06:39 EST 2006 | gipos
What about Juki -Zevatech feeders???
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Tue Feb 29 15:43:14 EST 2000 | jacob lacourse
Hello, I was looking for a few companies that make belt feeders for pic and place machines. This feeder will have to compatible with a quad machine. Thank you
Electronics Forum | Tue Feb 29 15:43:14 EST 2000 | jacob lacourse
Hello, I was looking for a few companies that make belt feeders for pic and place machines. This feeder will have to compatible with a quad machine. Thank you
.gif)
winsouce.jpg)