Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Sun Aug 07 14:37:50 EDT 2011 | franxsmt
Hi every body, Recently I got a vibration feeder for my SM421 Samsung machine. The feeder has no manual and I don't have any contact with Samsung people. I put the feeder into a feeder slot, the feeder goes on (a red lamp on the feeder indicates it
Electronics Forum | Fri Jun 04 14:04:36 EDT 2010 | dedwards
I have a question about assembleon vibration feeders. What is the process for loading tubes in these feeders? Our personnel are cutting the top of a tube end around the size of the part and glueing it into place. Then the machine is programmed for
Electronics Forum | Thu Jul 28 08:16:33 EDT 2005 | grantp
Hi, Your not using vibration feeder here are you? I have seen this a lot with vibration stick feeders. Regards, Grant
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Sun Aug 07 17:50:49 EDT 2011 | kahrpr
Samsung website dynatech if in usa http://www.samsung-smt.com/customer/saleservice.asp#mapArea
Electronics Forum | Tue Jun 10 22:57:18 EDT 2014 | demzvill
Our observation also is that the tape size is too big for the chip which allows the tape to move around. With this i would like to know if there is is a setting in the machine that would slow the feeding rate. We are using juki mounter 2000 series. A
Electronics Forum | Mon Aug 08 10:27:48 EDT 2011 | franxsmt
That's it!!! Thank you GEB! Actually the "transportation strap" seemed like a main part of the feeder, so I would never come to the idea to remove it. Now it vibrates like a rattlesnake's tail! Thank you very much for the tip. F.
Electronics Forum | Thu Apr 24 14:28:07 EDT 2003 | russ
Try PAC 972-422-1990
