Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym
Electronics Forum | Thu Feb 14 23:32:50 EST 2013 | padawanlinuxero
Hello ! I don't know if this helps but here goes, I have here 2 mydatas one a TP9-4 and the other MY12, on the TP9-4 we have TPSys 2.4 and we use a AM8 feeder magazine, when we bought the MY12 it came with TPSys 2.1, thinking we can use the AM8 feede
Electronics Forum | Fri Feb 15 08:37:44 EST 2013 | cyber_wolf
I think your MOT cards have to get upgraded too.
Electronics Forum | Thu Feb 14 17:00:42 EST 2013 | richardc
I am trying to use Mydata TM8C feeders that work fine on a TP93 running 1.6.18 TPsys but are not recognized by a TP94 machine running 1.4.7 TPsys. I get a green flashing light instead of a solid green. I can initialize the hardware but can not proc
Electronics Forum | Fri Feb 15 08:31:03 EST 2013 | cyber_wolf
I believe you need 1.5.13 or higher if I'm not mistaken to run the mags with the button upgrade. There is no way around it that I am aware of.
Electronics Forum | Thu Feb 16 11:23:04 EST 2006 | fredc
I saw WD-40 recomended as a lubricant for feeders. I might use it for a quick solvent rinse that I was planning to blow off all traces. Many years ago I put away some micrometers that had been sprayed with WD-40 after a year or so the solvents in the
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Wed Apr 18 15:10:35 EDT 2012 | smtivan
Dear Colleagues! Our organization has a lot of not-intellectual feeders for Essemtec Pick&Place CSM7000, but we would like to use this feeders in Essemtec CSM7100. Does it possible? What will we need to do for normal work of CSM7100 with old feeders
Electronics Forum | Wed Sep 21 12:14:47 EDT 2005 | Rob
It's quite a big cap so try taping over about 25% of both apertures to restrict the volume of paste printed then see what happens. Also, is anything interfering with the part during placement? or are you 100% sure it's going into the oven ok? if no
Electronics Forum | Thu Jul 01 16:15:34 EDT 2010 | claudea2
Thanks JMW, I noticed that, on one feeder you can turn the motor shaft three quarters of a revolution without moving the main sprocket wheel. Claude
