Electronics Forum | Thu Aug 27 21:52:15 EDT 1998 | Dan
| Thank you for visiting the new Admin Corner. Please feel free to comment on any parts and aspects of the SMTnet site. We will be inviting your opinions on various issues very soon. Cunli If I have forgotten my password, do I have to re-register o
Electronics Forum | Mon Apr 13 12:07:58 EDT 1998 | Tim Velardo
Wondering if anyone has information on percentage of components that we can expect to "lose" during our SMT process. We are new to SMT, using QUAD machines and feel we are losing to many parts during our process. We are spending a lot of touch-up ti
Electronics Forum | Wed Oct 02 11:44:58 EDT 2002 | slthomas
We found that a slightly more active flux was all we needed to provide sufficient wetting on the one AgPd part we put down. Unfortunately the paste we tried also slumped terribly, so we nixed that fix. It's a low volume product (50, once every 3 mo
Electronics Forum | Fri Dec 03 09:21:00 EST 2004 | Barb
We are implementing an AOL inspection system into our surface mount process. I would like to hear from anyone with an opinion on the different types of AOL and why they feel this is better than another one. Any information will be greatly appreciate
Electronics Forum | Fri Dec 03 09:21:20 EST 2004 | Barb
We are implementing an AOI inspection system into our surface mount process. I would like to hear from anyone with an opinion on the different types of AOL and why they feel this is better than another one. Any information will be greatly appreciate
Electronics Forum | Thu Jun 30 06:30:50 EDT 2005 | bobpan
Can you run the board on the other side of the oven??? Can you turn on the oven and set the heat real low and feel the air blowing down over the heaters???? You may be able to tell something is going on that way. Also make sure vibration isnt causing
Electronics Forum | Fri Sep 01 04:16:31 EDT 2006 | sant
Hi In my previous organistaion I had worked with LPKF m/c model C60 and have seen the T-tech m/c working also. I'll give the weightage to LPKF because of its performance. For your application I feel 100Krpm spindle will be more suitable. Support/serv
Electronics Forum | Mon Nov 20 10:06:05 EST 2006 | jdumont
Yes, we are in the same boat. We get stuff unsealed, not labeled correctly, wrong packaging or all of the above. Im going to sit down with the purchaser here this week and get this figured out. Being packaged correctly still doesnt mean the parts arn
Electronics Forum | Mon Jan 15 15:42:45 EST 2007 | realchunks
Dback is right. You're missing part of your manual. Once you perform steps 5-7 you should get an indication that you calibrated correctly. Man, it's a cardinal sin to recal conveyors once you have programs adjusted. Why did you feel the need to
Electronics Forum | Wed Feb 20 19:59:10 EST 2008 | pnguyvu
An experienced stencil designer suppose to check gerber data before making stencil it take 5 minutes to do this easily in computer after that analyze components if there's any critical parts in order to modify the aperture at USA STENCILS INC we have