Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Tue Jun 14 11:02:53 EDT 2005 | Stefan
I would rather take Bobpan's advise. If the placement is calculated from the center of two fiducials, than the placement should be off by 1/2 of the distance of the two fiducials, but not by the offset of that one fiducial. However, your approach in
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Tue Oct 18 14:59:35 EDT 2016 | muzzy
Hello. Our company recently bought a Samsung CP40V pick and place machine. It works very well, the software is intuitive but we have one problem. Is there a way to manually set fiducial position after machine failed to recognize it? For example, duri
Electronics Forum | Wed Jan 25 18:59:49 EST 2017 | superlen
When the fiducial fails, the machine stops with the crosshairs near the fid that couldn't be read. On the CP45 you just jog to the center and tell it use the position you just navigated to. (the manual correction). I believe the cp40 is the same...
Electronics Forum | Thu Aug 21 19:18:47 EDT 2008 | duchoang
My steps are different in that case: 1- Check mounts. Try to adjust origin point until get the pretty good mount positions. 2- Teach fiducials ( Board fids, not panel fids) 3- Use fids, check mount again. 4- If OK, then teach Block Repeat. This alwas
Electronics Forum | Tue Aug 19 13:35:51 EDT 2008 | stefi
Hello, I need an advice regarding the next issue: in the case of Assembleon Topaz or Emerald SMT machines, is there necessary to teach first the block repeat coordinates and after that the PCB fiducial coordinates when you do not have these coordina
Electronics Forum | Tue Mar 08 09:57:04 EST 2016 | rgduval
Make sure that your fiducials are selected to be used for global correction. I've had this problem with our machine running OS2, and in the UI for that, you have to select the fiducials in the fid screen, and then there's a menu option to select the
Electronics Forum | Tue Nov 11 13:25:17 EST 2014 | jimmyboz
I do not recall that "TEACH" ever worked. Even if it did, there is no way to save this data to the MCS. After you see that a fiducial cannot be found, change Xa-Ya in the program at the MCS to find it, and of course, re-transmit. Good Luck
