Electronics Forum | Tue May 15 04:15:36 EDT 2018 | godless
After reinstalling software, i get message when loading printer: "A printer file could not be opened, therefore the printer cannot be started. Please inster your calibration diskette and press confirm. or contact or contact DEK customer support. Pres
Electronics Forum | Wed May 16 00:14:45 EDT 2018 | leeg
We have a Dek Horizon and we have started getting a data file open error when trying to save files. This is resulting in us having to re-teach board fiducials etc in every time we switch back to a previous job. Any ideas?
Electronics Forum | Thu May 17 06:46:39 EDT 2018 | godless
After fresh install and loading only machinekey + stdeaf files it worked, thanks. But still there is camera problem which appeared from the beginning. I attached files where you can see error details. Software reinstallation not solved issue. Then ca
Electronics Forum | Thu Dec 09 13:22:24 EST 2010 | rodrigo
Hi All, I'm trying to use the F4G CP-4 optimizer. I cleared all the issues I was having except for this error I get at the end: Execute, 2030: Cycle Time table file not found I see a file in one of the folders named CP4_CYC.TBL but I'm not sure if
Electronics Forum | Wed May 16 07:03:23 EDT 2018 | dekhead
Recommend E;?configuration backup and install from scratch. Upon post-ghost do not reload configuration files, only machine keyfiles
Electronics Forum | Tue May 15 09:54:57 EDT 2018 | dekhead
What software release / system software are you installing? and what level of reinstallation? What prompted software reinstall?
Electronics Forum | Wed May 16 01:26:20 EDT 2018 | godless
I was instaling advantech 02.05(typhoon), Software Version 07 SP10 B06. Software reinstall was used because camera stopped working.
Electronics Forum | Thu May 17 08:26:05 EDT 2018 | dekhead
Is camera self-initializing upon power up? Please contact me directly dekhead@att.net
Electronics Forum | Wed Nov 07 14:24:50 EST 2018 | babe7362000
Is there a calibration file that saves on the Yestech after a Calibration is complete? and If so where is that located? Thanks
Electronics Forum | Fri Sep 01 15:52:03 EDT 2017 | wyluliwolf
Long story short: I paid someone to convert some older Gerber files to the new RS-274x format for me so I could have them manufactured. I sent them the original Gerber files (RS-274D) along with additional files showing information on the layout. T
winsouce.jpg)
.gif)