Electronics Forum | Wed Jan 30 13:17:22 EST 2019 | slthomas
In addition to robl's suggestions, I would look at the footprint on the board to make sure it meets the recommended dimensions. Abnormal layouts, particularly when pads extend under the component too far, can be problematic both by lifting the part
Electronics Forum | Wed Jan 30 03:01:39 EST 2019 | robl
You could use a stepped stencil around the parts you're having issues with to add a greater paste deposit to them and not the rest, or slightly elongate the apertures and overprint, but this may lead to solder balling.
Electronics Forum | Tue Jan 29 17:11:32 EST 2019 | slthomas
Your product is Class 3, correct? Otherwise, a clearly wetted connection is all you need.
Electronics Forum | Tue Jan 29 08:21:50 EST 2019 | electronics101
Hi All, Can someone please help, I have a number of tall surface mount components that according to IPC 610 (8.2.2.3) are a fail due to the end termination not wetting at least 0.5mm + solder height. The components are very well soldered but the sol
Electronics Forum | Wed Jan 30 02:50:33 EST 2019 | electronics101
Hi Steve Thanks for coming back to me, you are correct IPC class 3 is required. We are getting great wetting onto the device but not as per IPC 3 with the wetting rising about 0.25mm. I am questioning whether it is actually possible with such a (re
Electronics Forum | Thu Apr 17 13:00:28 EDT 2003 | Takfire
Russ, The caps are 0603 case size. I am not sure about the manufacturing details, as I work for the capacitor supplier. The manufacturing details are unclear at the moment, as the customer (South of the border) has not released such detailed inform
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Thu Apr 19 02:49:07 EDT 2007 | ray
I observed some black dot or some oxidation occured on chip termination on pcba reflowed fews weeks ago as buffer stock. The solder joint and fillet wetting is good and shinning. It is an acceptable or defect condition per IPC standard/requirement? W
Electronics Forum | Wed Aug 25 15:47:25 EDT 1999 | JohnW
| | | | | Could use a little help here. Can anyone clarify to me the cause and fix of chip caps/resistors tombstoning following reflow? | | | | | | | | | | Any help would be appreciated. Thanks. | | | | | | | | | Most common reason is uneven hea
Electronics Forum | Wed Aug 25 16:42:32 EDT 1999 | Dave
| | | | | | Could use a little help here. Can anyone clarify to me the cause and fix of chip caps/resistors tombstoning following reflow? | | | | | | | | | | | | Any help would be appreciated. Thanks. | | | | | | | | | | | Most common reason is