Electronics Forum | Mon Jul 01 09:31:33 EDT 2013 | emeto
I know Juki have some software for optimization but you have to purchase it. From experience though I don't find Software as the strong part of Juki machines.
Electronics Forum | Thu Jul 18 12:08:52 EDT 2013 | ericrr
Thats OK, no doubt your formula works, or you would not keep it. So does mine, without the 2t, (that is way I asked) I must go and find it, or rework it out since my old thread has gone from this web site.
Electronics Forum | Thu Jul 18 16:53:08 EDT 2013 | ejurentkuff
Our biggest concern is "head in pillow". I need something that can easily find this defect and call it out. I don't want something that I need an operator reviewing for pass/fail.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Tue Sep 24 11:15:45 EDT 2013 | James Whitehouse
Hi, Boot the station computer with a dos disk, open real.ma with an editor, find the adresse near the top and get it to match what you have configured in your line computer. BR
Electronics Forum | Thu Aug 08 16:13:21 EDT 2013 | rangarajd
Hello All, Are there any documents that list component spacing requirements in terms of DFM/ DFA. I was going through IPC website but wasn't able to find any. Thanks!
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Fri Sep 06 12:22:51 EDT 2013 | nophsem
the list doesn't include anything :-( What information should I find? what is referred to laser MODs are 64, 67 and 71, I can you mention some other
Electronics Forum | Fri Sep 20 11:57:47 EDT 2013 | emeto
It will be very hard to find anything on this prize. You also have to know that if the machine cost is 15k, the feeders cost might be about the same amount or even more. Even manual placers will probably cost you more. Just try to change the budget.
Electronics Forum | Fri Oct 04 12:22:46 EDT 2013 | hegemon
Can't find anything on this oven. You might try to contact a representative such as http://www.gemosz-elektronika.hu/eng/smd_machines_p.html Good luck!