Electronics Forum | Wed Oct 10 13:13:44 EDT 2007 | jsloot
Any body using any kind of special finger marker stickers used to check wave solder conveyor fingers parellism? If so please contact me.
Electronics Forum | Wed Jan 03 23:00:18 EST 2007 | new guy
I'm a new guy in this field. I have a question about solder paste process. Is there any effect to the solderbility if we do a lot of contact to copper pad without using any insulation ( direct to the finger ). Where can i get information about smt pr
Electronics Forum | Fri May 28 13:03:14 EDT 2021 | cbart
I'm honestly not sure IPC addresses this? the one thing i would ask myself if it were my issue: is the effected area in the critical contact area of the finger/contact? in other words if its low on the finger where the bevel was applied i bet its not
Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Thu Feb 10 13:54:22 EST 2000 | Kris W
Hi All, We are in the process of converting from RMA solder paste to no-clean process across the shop. This will allow me to carry my semi-aqueous cleaner out of the building and set it ablaze using the terpenes as the fire water. Then I can go ab
Electronics Forum | Sun Jul 26 22:35:55 EDT 1998 | D.Lange
Masdi, Try board shunts. They are hi-temp rubber strips with grooves cut. They can be popped on and off with ease and are much faster than taping and considerably cheaper. They also work great for masking goldfingers prior to wave soldering. Contac
Electronics Forum | Sun Sep 22 13:14:56 EDT 2002 | scottefiske
Stop the lines...! Stop building defects and rework into your product. Contact Fab Supplier and have pipeline filled for small amount of replacement fabs to keep lines running and limiting production scheduling and impact. Request to have the board
Electronics Forum | Wed Sep 18 22:53:24 EDT 2002 | davef
Please give us background on your situation, so that we can focus on the specifics, for instance: * This is a bare board problem, correct? Then, this contamination causes what the problems in your process? * What is the type [ie, FR4, CEM1, etc] of
Electronics Forum | Mon Aug 03 08:23:37 EDT 1998 | smd
Stevens Products (supposedly around since 1937) 128 N. Park St. E. Orange, NJ 07019 Tel 973-672-2140 Contact: Ross Stevens, Jr. They'll take a PO but terms are net 30 Right now we are taping the goldfingers which is | effective but also expensive. A
Electronics Forum | Tue Mar 20 02:22:22 EST 2001 | PeteC
Can anybody advise on repairing PWB edge gold contact fingers that get solder on them?